FORTIN 102771 2012 Chevrolet Caprice Regular Key Remote Starters and Alarm Systems Installation Guide
- June 13, 2024
- FORTIN
Table of Contents
FORTIN 102771 2012 Chevrolet Caprice Regular Key Remote Starters and
Alarm Systems
ONLY COMPATIBLE WITH AUTOMATIC TRANSMISSION VEHICLES
Vehicle functions supported in this diagram (functional if equipped)
Vehicle functions
STAND ALONE CONFIGURATION
REMOTE STARTER FUNCTIONALITY
REMOTE STARTER WARNING CARD
CUT THIS WARNING CARD AND STICK IT ON A VISIBLE PLACE: or use the package RSPB, Sold separately.
WARNING
REMOTE STARTER
THE VEHICLE CAN BE STARTED BY EITHER: PRESSING THE LOCK BUTTON ON THE OEM REMOTE 3 TIMES CONSECUTIVELY OR BY A SMARTPHONE. TURN ON THE SAFETY SWITCH LOCATED UNDER THE DASHBOARD BEFORE WORKING ON THE VEHICLE.
DESCRIPTION
WIRING CONNECTION
KEY BYPASS PROGRAMMING PROCEDURE 1/2
-
Press and hold the programming button: Connect the 4-PIN Data-link harness (Black connector).
The Blue, Red, Yellow and Blue & Red LEDs will alternatively illuminate. -
Release the programming button when the LED is BLUE.
If the LED is not solid BLUE disconnect the 4-Pin connector (Data-Link) and go back to step -
Insert the required remaining connectors.
-
Turn the key to the Ignition ON/RUN position.
- The Blue LED will flash rapidly.
-
Press and release the programming button once (1x).
- The Blue LED will turn OFF.
- The YELLOW and RED LEDS will alternate.
-
Turn the key to the OFF position.
-
Disconnect all the connectors and after the Data-Link (4-pins) connector.
KEY BYPASS PROGRAMMING PROCEDURE 2/2
Notice: Updated Firmware and Installation Guides Updated fi rmware and installation guides are posted on our web site on a regular basis. We recommend that you update this module to the latest fi rmware and download the latest installation guide(s) prior to the installation of this product.
WARNING
The information on this sheet is provided on an (as is) basis with no
representation or warranty of accuracy whatsoever. It is the sole
responsibility of the installer to check and verify any circuit before
connecting to it. Only a computer safe logic probe or digital multimeter
should be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no liability or
responsibility whatsoever pertaining to the accuracy or currency of the
information supplied. The installation in every case is the sole
responsibility of the installer performing the work and FORTIN ELECTRONIC
SYSTEMS assumes no liability or responsibility whatsoever resulting from any
type of installation, whether performed properly, improperly or any other way.
Neither the manufacturer or distributor of this module is responsible of
damages of any kind indirectly or directly caused by this module, except for
the replacement of this module in case of manufacturing defects. This module
must be installed by qualifi ed technician. The information supplied is a
guide only. This instruction guide may change without notice. Visit
www.fortinbypass.com to get the latest version.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>