FORTIN 58881 Acura TL 2010 Standard Key Remote Starters And Alarm Systems Installation Guide
- June 13, 2024
- FORTIN
Table of Contents
FORTIN 58881 Acura TL 2010 Standard Key Remote Starters And Alarm Systems
REGULAR INSTALLATION
- HARDWARE VERSION MINIMUM 6
- FIRMWARE VERSION 73.[30] HONDA/ACURA MINIMU
To add the firmware version and the options, use the FLASH LINK UPDATER or FLASH LINK MOBILE tool, sold separately.
Program bypass option
IF THE VEHICLE IS NOT EQUIPPED WITH FUNCTIONAL HOOD PIN
UNIT OPTION OPTION UNITE
- A11 OFF NON
DESCRIPTION
- Hood trigger (Output Status).
- Contact de capot (état de sortie).
Parts required
- 1X FUSE
- 1X 1AMP DIODE (WITHOUT DATA-LINK)
MANDATORY INSTALL
HOOD STATUS : * HOOD PIN THE HOOD PIN SWITCH MUST BE INSTALLED IF THE
VEHICLE CAN BE REMOTE STARTED WITH THE HOOD OPEN, SET FUNCTION A11 TO OFF
Notice : the installation of safety elements are mandatory. The hood pin
is an essential security element and must be installed.
THIS MODULE MUST BE INSTALLED BY A QUALIFIED TECHNICIAN. A WRONG CONNECTION
CAN CAUSE PERMANENT DAMAGE TO THE VEHICLE
This guide may change without notice. See
www.fortin.ca for latest version.
DESCRIPTION
AUTOMATIC TRANSMISSION WIRING CONNECTION
PROGRAMMING PROCEDURE
-
Press and hold the programming button: Insert the 4-Pin (Data-Link) connector
- The Blue, Red, Yellow and Blue & Red LEDs will alternatively illuminate
-
Release the programming button when the Red LED is ON.
- If the Red LED is not ON solid disconnect the 4-PIN Data-Link harness (Black connector) and go back to step 1.
-
Insert the required remaining connectors.
-
Press and release the programming button twice (2x).
-
The RED LED will flash once and pause.
-
Turn the key to the Ignition
ON/RUN position. -
The Red LED will flash 10 times rapidly.Key bypass programmed.
-
The Blue LED will flash rapidly. CAN-Bus programmed.
-
Turn the key to the OFF position.
-
The Blue LED will turn off.
The module is now programmed
Use the remote of the remote starter / security system to test all the
supported features and ensure all the features are properly programmed.
Module label
Notice: Updated Firmware and Installation GuidesUpdated fi rmware and installation guides are posted on our web site on a regular basis. We recommend that you update this module to the latest fi rmware and download the latest installation guide(s) prior to the installation of this product.
WARNING
The information on this sheet is provided on an (as is) basis with no
representation or warranty of accuracy whatsoever. It is the sole
responsibility of the installer to check and verify any circuit before
connecting to it. Only a computer safe logic probe or digital multimeter
should be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no liability or
responsibility whatsoever pertaining to the accuracy or currency of the
information supplied. The installation in every case is the sole
responsibility of the installer performing the work and FORTIN ELECTRONIC
SYSTEMS assumes no liability or responsibility whatsoever resulting from any
type of installation, whether performed properly, improperly or any other way.
Neither the manufacturer or distributor of this module is responsible of
damages of any kind indirectly or directly caused by this module, except for
the replacement of this module in case of manufacturing defects. This module
must be installed by qualifi ed technician. The information supplied is a
guide only. This instruction guide may change without notice. Visit
www.fortinbypass.com to get the latest version
Copyright © 2006-2018, FORTIN AUTO RADIO INC ALL RIGHTS RESERVED PATENT
PENDING
www.fortinbypass.com
WEB UPDATE
TECH SUPPORT
Tél: 514-255-HELP (4357) 1-877-336-7797