FORTIN 58831 Acura TL 2010 Standard Key Remote Starters And Alarm Systems Installation Guide
- June 13, 2024
- FORTIN
Table of Contents
FORTIN 58831 Acura TL 2010 Standard Key Remote Starters And Alarm Systems
ADDENDUM – SUGGESTED WIRING CONFIGURATION
- BYPASS FIRMWARE VERSION VERSION LOGICIELLE CONTOURNEMENT 73.[38] HONDA/ACURA MINIMUM
- To add the firmware version and the options, use the FLASH LINK UPDATER or FLASH LINK MOBILE tool,sold separately.
- Program bypass option IF THE VEHICLE IS NOT EQUIPPED WITH FUNCTIONAL HOOD PIN:
UNIT OPTION OPTION UNITE/DESCRIPTION
OFF/NON
- A11: Hood trigger (Output Status).
MANDATORY INSTALL
- HOOD PIN
HOOD STATUS : THE HOOD PIN SWITCH (INCLUDED) MUST BE INSTALLED IF THE VEHICLE CAN BE REMOTE STARTED WITH THE HOOD OPEN, SET FUNCTION A11 TO OFF.
Notice: the installation of safety elements are mandatory. The hood pin and the sticker are essential security elements and must be installed.
THIS MODULE MUST BE INSTALLED BY A QUALIFIED TECHNICIAN. A WRONG CONNECTION CAN CAUSE PERMANENT DAMAGE TO THE VEHICLE.
DESCRIPTION
AUTOMATIC TRANSMISSION WIRING CONNECTION
KEY BYPASS PROGRAMMING PROCEDURE
- Press and hold the programming button: Insert the 6-Pin Main connector.
- The LEDs will alternate between BLUE, RED, YELLOW & BLUE/RED flashes.
- Release the programming button when the LED is RED.
- If the LED is not solid RED disconnect the 6 Pin connector (Main-Harness) and go back to step 1.
- Insert the required remaining connectors.
- Press and release the programming button twice (2x).
- The RED LED will flashonce and pause
- Turn the Ignition to theON/RUN position.
- The RED LED will flash rapidly 10x times.
- Key bypass programmed. 4The BLUE LED will flashrapidly. CAN-Bus programmed.
- Turn the Ignition to the OFF position.
- The BLUE LED will turn off.
The module is now programmed.
Use the remote of the remote starter or security system to test all of the
supported features toensure proper programming.
REMOTE STARTER PROGRAMMING PROCEDURE
Notice: Updated Firmware and Installation Guides
Updated fi rmware and installation guides are posted on our web site on a
regular basis. We recommend that you update this module to the latest fi
rmware and download the latest installation guide(s) prior to the installation
of this product.
WARNING
The information on this sheet is provided on an (as is) basis with no
representation or warranty of accuracy whatsoever. It is the sole
responsibility of the installer to check and verify any circuit before
connecting to it. Only a computer safe logic probe or digital multimeter
should be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no liability or
responsibility whatsoever pertaining to the accuracy or currency of the
information supplied. The installation in every case is the sole
responsibility of the installer performing the work and FORTIN ELECTRONIC
SYSTEMS assumes no liability or responsibility whatsoever resulting from any
type of installation, whether performed properly, improperly or any other way.
Neither the manufacturer or distributor of this module is responsible of
damages of any kind indirectly or directly caused by this module, except for
the replacement of this module in case of manufacturing defects. This module
must be installed by qualifi ed technician. The information supplied is a
guide only. This instruction guide may change withoutnotice. Visit
www.fortinbypass.com to get the latest version.
TECH SUPPORT
- Tél: 514-255-HELP (4357)
- 1-877-336-7797
- www.fortinbypass.com.
- INTERFACE MODULE
- Made in Canada
- PATENTS PENDING US: 2007-228827-A1
- www.fortinbypass.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>