profi-pumpe SP02119-2-1 Solar Fountain Instruction Manual

: June 12, 2024
: profi-Pumpe

profi-pumpe SP02119-2-1 Solar Fountain

profi-pumpe-SP02119-2-1-Solar-Fountain-product

Product Information

Product Name: Solar Fountain Solar-Brunnen
Model: KLASSIK-GARTEN-2-1 with LED-Light SP02119-2-1
Version: 23.04
Manufacturer: Profi-Pumpe
Website: www.profi-pumpe.de

Safety Instructions and Warnings

Please read the user manual before using the pump.
Follow all safety precautions and instructions for proper use to prevent injury or property damage.
Keep the manual and safety instructions for future reference.

Product Usage Instructions

Unpack all components carefully. Ensure you have received the following parts:
- 1pc Upper column
- 1pc Upper reservoir
- 1pc Lower column
- 1pc Lower reservoir
- 1pc Base
- 1pc Pump
- 1pc LED light
- 1pc Solar panel
- 1pc Solar panel bracket
- 1pc Extension tube
- 1pc Ground spike
Remove any protective film from the solar panel.
Position the solar panel in a location where it receives direct sunlight. The fountain will not work if the solar panel is shaded.
Adjust the solar panel angle to maximize the amount of solar energy collected.
Connect the pump to the solar panel.
Ensure that the flow is fully open to allow water circulation. If the flow is restricted, little or no water will be pumped.
Frost: In freezing temperatures, empty the pump, pipes, and water tank. Rinse them with clean water and store them dry to prevent damage.
Assembly Instructions:
Place the lower reservoir on top of the base and twist it clockwise to secure.
Feed the pump power cord through the plastic tube towards the bottom of the base. The cord should exit from the channel on the bottom of the base.
Place the upper reservoir onto the lower column and twist it clockwise to secure.

Technical changes, misprints and mistakes reserved! Newest information about our products can be found online. http://www.profi-pumpe.de.

SAFETY INSTRUCTION AND WARNINGS

Please read the user manual before using the pump
Warning sign

INTRODUCTION

We would like to congratulate you on the purchase of our pump. We appreciate your trust. That‘s why functional security and operational safety stands on first place for us.

To prevent damage to persons or property, you should read this user manual carefully. Please observe all safety precautions and instructions for proper use of the pump. Failure to follow the instructions and safety precautions can result in injury or property damage. Please keep this manual with the instructions and safety instructions carefully in order to at any time you can restore them.

IN GENERAL

Solar Pond Pump Kits are high-quality fountain pump systems for energy use in outdoor or indoor use. The perfect eye-catcher in your garden or seed tray. Through the use of high-quality solar technology with Li-Ion batteries are the Solar Pond Pump Kits mains-independent and anywhere to use immediately.

It‘s recommended NOT to conduct yourself technical modifications. First, it is not certain whether these changes are technically correct and, secondly, because no guarantee can be granted.
Transport damages are immediately to be reported to the package distributor and to us in written form. Failure to give timely notice to the shipping company, and are therefore rejected your claims from the transport company, so we can not accept these claims as well. In your legal obligation to cooperate to minimize damage, we point out expressly herewith.

OPERATION

Unpack all components carefully. You should have received the following parts:
- 1pc Upper column / 1pc Upper reservoir / 1pc Lower column / 1pc Lower reservoir / 1pc Base / 1pc pump / 1pc LED light / 1pc Solar panel / 1pc Solar panel bracket / 1pc Extension tube / 1pc Ground spike
- To protect the product, place all parts on a soft surface before assembly.
Remove the protective film from the solar panel (if any).
Position the solar panel so that it receives direct sunlight. The fountain can not work if the solar panel is shaded. Adjust the solar panel angle to maximise the amount of solar energy collected. Connect the pump on the panel (see item 5). Check whether the flow is fully open (or else promoted little or no water). $profi-pumpe-SP02119-2-1-Solar-Fountain-fig- $1$$

FROST
Frost can cause damage to the pump. In freezing the pump, pipes and water tank must be emptied, rinsed with clean water and stored dry.

ASSEMBLY INSTRUCTION

The set is not pre-connected and you need to assemble this. Place lower reservoir on top of base and twist the lower reservoir clockwise to secure.
Feed the pump power cord through plastic tube toward bottom of base. Cord exit out from channel on the bottom of the base.
Place upper reservoir onto lower column and twist the upper reservoir clockwise to secure.
Place upper column into upper reservoir and twist the upper column clockwise to secure.
Attach pump to the rubber hose. Then place the upper fountain body into lower reservoir an twist the upper fountain body clockwise to secure.
Fill reservoir with appropriate amount of water to completely submerse the pump.
Note: Destilled water is recomended to reduce mineral deposits and bacteria build-up.
Join bracket, tube and spike together, then attach bracket to back of the solar panel as shown.
Twist pump plug slightly and pushing it into the pump socket. Then twist LED light plug slightly and pushing it into the light socket. Make sure the sealing ring is fully in groove
Press bottom tip in the ground. Make sure that the solar panel receives direct sunlight and is not shaded by trees or buildings.

PERFORMANCE

The performance of the pump depends on the orientation of the solar panels toward the sun and the intensity of the max. Data obtained under optimal conditions. Function in the shade or on cloudy days can not be guaranteed. In models with battery operation depends on the function of the battery is charged.

Press ON/OFF button on back side of the solar panel to turn on the pump. The battery indicator lamp will be on. With „Press“ is always meant „touching“, because a sensor is used as a „Pushbutton“.
Press ON/OFF button on back side of the solar panel to turn off the pump. The battery indicator lamp will be off.
The LED light only works, when day goes dark.
When battery power is low, the system will automatically shut off the pump to protect the battery. The indicator lamp will be off in this case. The pump can not work, until the battery is recharged. The recharging time should depend on sunlight conditions.
The charging process will be interrupted as soon as the battery is fully charged to prevent overcharging.
The pump will automatically start next morning, when solar panel receives enough sunlight.

NOTE:
The battery is supplied charged. If the state of charge, contrary to expectations, not be sufficient to charge the batteries for at least 8 hours to allow sufficient charging of the battery (so damage the battery to avoid overcharging, the pump must be connected).

WARNINGS ON BATTERY

Lithium Ion cells and battery may get hot, explode or ignite and cause serious injury if they are exposed to abusive conditions, Be sure to follow the safety warnings listed below:

Do not install the battry backwards, so the polarity is reversed
Do not connect the positive or/and negative terminal or/and the battery to each other with any meta object, such as wire
Do not disassemble or modify the battery. The battery contains safety and protection devices which may cause the battery to generate heat, explode or ignite if damaged
Do not place the battery in or near fire, on stoves or other high temperature locations. Do not place the battery iiin direct sunlight or use/store the battery inside cars during hot weather. Doing so may cause the battery to generate heat, explode or ignite
It is not advised for children to handle the battery
When the battery is worn out, wrap the terminals with adhesive tape or similar materials before disposal
Immediately discontinue use of the battery, if there is an unusuak smell, a change of color or shape, or if it appears abnormal in any other way
Do not place the battery in microwave ovens, high pressure containers or on cookware facilities
In the event of the battery is leaking and fluid gets into your eye, do not rub the eye, rinse well with water and imme-diately seek medical advice. If left untreated, the battery fluid could cause serious injury to the eye

BATTERY REPLACEMENT

After used for 12 to18 months, the battery have reached it‘s service life, you should replace the battery. Unscrew the battery cover, replace the battery with a new one. Please pay attention to limited Warranty: 3 months.

How to replace the battery:

Remove LED light plug and pump plug from solar panel
Remove cover from solar panel above by unscrewing (6) screws
Disconnect the connectors, then replace the old battery pack with a new battery pack and join the connectors together
Secure the cover to solar panel with the 6 screws you removed $profi-pumpe-SP02119-2-1-Solar-Fountain-fig- $11$$

SECURITY TIPS

Obey absolutely valid regulations on the electrical security
Never run pump dry
Pumping inflammable, as well as all other aggressive liquids is prohibited
Pay attention to the medium max. 40°C
Any altering of the product itself or changing of the components is forbidden.
With longer unused times, clean the pump, wash it out with clear water, dry and store it at room temperature
Do not connect the pump to any AC voltage power directly, it’s ONLY for DC Voltage power.
Operate the pump in freshwater or saltwater only (never above 50°C), especially keep it away from flammable liquids.
All solar panels are very sensitive, protect it before all against external mechanical influences (shock, vibration, etc.)

The manufacturer explains:

To take over no responsibility in the case of accidents or damages on the basis of carelessness or disregard to the instructions in this book.
to reject every responsibility for the damages which originate from the improper use of the pump

SERVICING

If after some time the pump starts losing power or stops working, please clean up sediment in the pump shell or filter cribs. Kindly note the pump can be opened by pressing down at the bottom of the filter housing. To clear the impeller, open the pump housing at the front by sliding up the front plastic cover.

The solar module should only be cleaned with soft tissue or propriety glass cleaning solution.

Front case
Filter
Impeller cover
Impeller
Pump

GUARANTEE REGULATIONS

For all manufacturer defects and material defects we grant the legal guarantee time (new and unused product). In such cases we take over the exchange or the repair of the pump. Forwarding expenses are not carried by us.

The guarantee is not valid with:

Material wear (sealing rings, impeller wheels, impeller chambers)
Unjustified interventions or changes in the pump
Damages by selffault
Improper servicing and improper use
DRY RUN (Also partially!) of the pump

Moreover, we give no damage compensation for secondary damages!

RECOGNISING AND REPAIRING OF MISTAKES

Problem	Possible cause	Solution

Pump will not turn on

| No sunlight| The orientation of the solar panels up to the sun
Low charge level of the battery| See item 6 and 8 (Note)
Pump connector is not connected correctly| See item 5.8
Defective pump / solar panel broken| Replace pump or solar panel

Pump runs but no water is encouraged

| ****

Pump impeller and filter housing polluted

| Disassemble and clean in accordance with point 10, the pump and the housing (by means of water and a soft brush)
The flow controller to the pump is closed| Open the flow regulator on the pump
Pump has sucked air| Turn off the pump briefly and then back on (restarting) Attention! Avoid dry running
Coarsining or fountain nozzles dirty| Disassemble and clean the tube and the fountain nozzle

NOTES ON PRODUCT LIABILITY
We point out, that we are only liable for damages under the Product Liability Act, which are caused by our units if no changes were made to the equipment. We are only liable for repairs, if original spare parts and accessories were used and repairs are carried out by our authorized service.

NOTES ON DISPOSAL

Electro devices of our company, labeled with the symbol of the crossed trash bin, are not permitted to be disposed in your household garbage. We are registered at the German registration department EAR under the WEEE-No.
DE79535656. This symbol means, that you’re not allowed to treat this product as a regular household waste item – it has to be disposed at a recycling collection point of electrical devices. This is the best way to save and protect our earth.
THANK YOU FOR YOUR SUPPORT!
In connection with the sale of batteries or with the delivery of equipment containing rechargeable battery packs, the seller is obliged to draw your attention to the following:
- You are obliged to return used batteries as an end-user. You can return batteries after use to the seller or to the designated collection facilities, which are free of charge (eg: municipal collection points or in stores). You can return the batteries for disposal at no charge to the seller.

DECLARATION OF CONFORMITY

EU DECLARATION OF CONFORMITY
The undersigned, Amur S.à r.l., 36, Rue de la Gare, L-5540 Remich, certifies that the product named overleaf, namely KLASSIK-GARTEN-2-1 as placed on the market, complies with the relevant provisions listed below, the relevant EU harmonised directives and the EU standard for safety. This declaration of conformity applies insofar as no modifications are made to the product. The sole responsibility for issuing this declaration of conformity lies with the manufacturer. The sole authorised person to keep the technical documents:

Amur S.à r.l. – 36, Rue de la Gare – L-5540 Remich

EC Electromagnetic compatibility directive (2014/30/EU)
The following harmonized standards: EN 55014-1: 2017, EN 55014-2:2015

ROHS: 2011/65/EU

Signed for and on behalf of:

TECHNICAL DATA

Pump	Max. pump capacity	250 l/h
Max pump height	90 cm
Max. water temperature	40 °C
Solar module	Rated voltage	9 V
Amperage	0,222 A
Power	2 W
Dimension (LxWxH)	190x150x18mm
General	Protection grade, Panel/Pump	IP44 / IP68
Dimension (LxWxH)	58x58x112cm
Total weight	ca. 14 kg
Length of cable	5 m
Battery type	Li-Ion 7,4 V/1.2AH
Ambient temperature	0°C – 45°C

SPARE PARTS

The spare parts are available for purchase from AMUR S.à.r.l. at www.profi- pumpe.de.

SPARE PARTS| | Technik Set- 1.1
for solar decoration with Li-Ion batteries / LED light

$profi-pumpe-SP02119-2-1-Solar-Fountain-fig- $16$$

---|---|---
Solar panel|
Power| 9 V / 2 Watt
Protective class| IP44
Dimension (LxWxH)| 190 x 150 x 18mm
Capacity| 7.4V/1.2Ah
Battery Type| Li-Ion
Pump|
Pump power| 1,4 W
Max. pump capacity| 250 l/h
Max pump height| 90 cm
Max. water temperature| 35 °C
Protective class| IPX8