TORO 147-1880 Mounting Bracket Kit Revolution 60V 6 Pod Battery Charger Instruction Manual
- June 12, 2024
- Toro
Table of Contents
Mounting Bracket Kit
Revolution 60V 6-Pod Battery Charger
Model No. 147-1880
Installing the Mounting Bracket
Install the mounting bracket indoors (such as a garage or other dry place), near a power outlet, and out of the reach of children.
-
Secure the mounting bracket in place using the appropriate hardware in the pre-drilled holes (hardware not included).
Note: You can install the mounting bracket so that the charger and batteries stand upright or lie flat.
1. 41 cm (16 inches) spacing between
holes
2. 61 cm (24 inches) spacing between holes -
Thread the power cable through the side of the mounting bracket and tilt the top of the charger so that it fits underneath the mounting bracket tabs (Figure 2).
1.
Mounting bracket tabs -
Secure the charger to the bracket using the straps as shown in Figure 3.
A. Loop the strap through the slot in the bracket.
B. Loop the strap around the charger handle and back through the buckle of the strap.
C. Secure the strap to itself.
-
Repeat step 3 to secure the other side of the charger.
© 2023—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>