BEGA 50093.1 Wall Luminaire for Indoor Use Instruction Manual
- June 13, 2024
- BEGA
Table of Contents
50093.1 Wall Luminaire for Indoor Use
Technical amendments reserved
Wall luminaire for indoor use
Instructions for use
Application
Enclosed and free-radiating wall luminaire made
of hand-blown opal glass, with metal housing,
for all lighting tasks in interior applications.
Product description
Metal luminaire housing,
finish Colour white
Hand-blown opal glass
Metal shield, white
2 mounting holes ø 4.5 mm
Distance apart 138 mm
2 cable entries for through-wiring for mains
cable up to ø 10.5 mm max. 3 × 1.5@
Connection terminal 2.5@
Earth conductor connection
LED power supply unit
220-240 V y 50-60 Hz
BEGA Thermal Switch®
Temporary thermal shutdown to protect
temperature-sensitive components
Safety class I
r – Safety mark
c – Conformity mark
Weight: 1.1 kg
This product contains light sources of energy
efficiency class(es) D
Safety
The installation and operation of this luminaire
are subject to national safety regulations.
Installation and commissioning may only be
carried out by a qualified electrician.
The manufacturer accepts no liability for
damage caused by improper use or installation.
If subsequent modifications are made to
the luminaire, the person responsible for
these modifications shall be considered the
manufacturer.
Overvoltage protection
The electronic components installed in the
luminaire are protected against overvoltage in
accordance with DIN EN 61547.
To achieve an additional protection against
e. g. transients, etc. we recommend separate
overvoltage protection components.
You can find them on our website at
www.bega.com.
BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden · info@bega.com · www.bega.com
Lamp
Module connected wattage 7.9 W
Luminaire connected wattage 10 W
Rated temperature ta = 25 °C
Ambient temperature ta max = 25 °C
50 093.1 K3
Module designation LED-0589/930
Colour temperature 3000 K
Colour rendering index CRI > 90
Module luminous flux 1040 lm
Luminaire luminous flux 529 lm
Luminaire luminous efficiency 52,9 lm / W
Installation
The luminaire must only be operated with the
complete protective cover.
LED are high-quality electronic components!
Please avoid touching the light output opening
of the LED directly during installation or
relamping.
Lead the mains supply cable through the
cable entry into the luminaire housing.
Fix the mounting plate with enclosed or any
other suitable fixing material onto the mounting
surface.
Be sure to use the gasket rings supplied.
Make earth conductor connection.
Push silicone sleeves over the lines
and make electrical connection.
Insert the glass into luminaire housing and fix it
by screwing the shield hand-tight clockwise
onto the glass.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free
cleansers from dirt.
Defective glass must be replaced.
Replacement of the LED module
The designation of the LED module is noted on
a label in the luminaire.
The light colour and light output of BEGA
replacement modules correspond to those of
the modules originally fitted.
The module can be replaced by qualified
persons using standard tools.
Disconnect the system and open the luminaire.
Please follow the installation instructions for the
LED module.
Defective glass must be replaced.
Close the luminaire.
Spares
Spare glass 11 003 166 .1
LED power supply unit DEV-0177/350
LED module 3000 K LED-0589/930
Shield 72 000 862 M
BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden · info@bega.com · www.bega.com