EWA A106 Pro Wireless Mini Bluetooth Speaker User Guide

June 14, 2024
EWA

Welcome Guide
A106Pro Wireless Speaker

Using Your Speaker

  1. Turn it on
  2. Pair it with your device
  3. Charge your speaker

Warm reminder:
The speaker will make a “beep” sound every a few seconds when the battery is less than 15%. Please charge it.

Controls

Play/ Pause

Press and hold 2 seconds

LED Indicator guide

Flashing blue
Pairing mode
Connected to a device

Charging
Light off

Reset

The reset button was designed on the downward of the passive radiator, press down it for about 0.5cm to click the reset button.
While the product crashed or can’t pair with other devices, please use the reset button.

Warning:

  1. The reset button was only supposed to be pressed when the product is under un-normal status.
  2. When press the reset button, transient currents may causes damage of components, avoid unnecessary reset operations.
  3. Please do not hold the reset button over 1s.

Having connection problems? Remove speaker from your device’s wireless history, ensure it’s less than 3 feet away then try pairing again.

 Spcifications

Wireless Version 5.0
Supported Profiles HSP, HFP, A2D and AVRCP
Battery Capacity 700 mAh
Operating Range 20 m / 66 ft
Audio Output 3W
Size Dia.48 x H40mm

Dia.1.89 x H1.58in
Weight| 182g / 6.420z
Waterproof Level| IP67

Attention

Don’t disasseemble
Aviod dropping

Aviod extreme temperatures

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

  1. Reorient or relocate the receiving antenna.
  2. Increase the separation between the equipment and receiver.
  3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  4. Consult the dealer or anexperienced radio / TV technician for help.

RF Warning Statement

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

info@ewacn.com
+86-755-29918835
+81(0)50-313-66188
@EWA_JP
@EWA_JP
www.ewacn.com
J.Y.M. Electronics Co.,Ltd.
Shajing, Bao’an, Shenzhen China 518000

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals