BEGA 50649.3 Ceiling and Wall Luminaire for Indoor Use Instruction Manual

IP 64
50 649.3
Technical amendments reserved
Ceiling and wall luminaire for indoor use
Instructions for use

50649.3 Ceiling and Wall Luminaire for Indoor Use

Application

Ceiling and wall luminaire · indoor luminaire made of aluminium and hand-blown opal glass, satin matt.
For a variety of lighting applications.

Product description

Luminaire made of Aluminium, finish Polished aluminium
Hand-blown opal glass, satin matt, with screw neck
Silicone gasket
2 mounting holes ø 5.5 mm
Distance apart 220 mm
2 cable entries for through-wiring for mains
cable up to ø 10.5 mm max. 3 × 1.5@
Connecting terminal 2.5@
with plug connection
Earth conductor connection
LED power supply unit
220-240 V **0/50-60 Hz
DC 170-280 V
BEGA Thermal Switch®
Temporary thermal shutdown to protect temperature-sensitive components
Safety class I
Protection class IP 64
Dust-tight and protection against splash water
Impact strength IK05
Protection against mechanical
impacts < 0.7 joule
– Safety mark
– Conformity mark
Weight:** 2.6 kg
This product contains light sources of energy efficiency class(es) D

Safety

The installation and operation of this luminaire are subject to national safety regulations.
Installation and commissioning may only be carried out by a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or installation.
If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.

Overvoltage protection

The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e. g. transients, etc. we recommend separate overvoltage protection components.
You can find them on our website at www.bega.com.
Lamp

50 649.3 K3

Installation

LED are high-quality electronic components!
Please avoid touching the light output opening of the LED directly during installation or relamping.
Loosen hexagon socket head cap screws (4x).
Disassemble LED module.
Loosen LED-connection and earth connection (plug connection).
Dismantle the mains supply cable.
Lead mains supply cable through the cable entry into the luminaire housing.
Fix the luminaire housing with enclosed or any other suitable fixing material onto the mounting surface.
It is imperative to use the enclosed gaskets.
Push silicone sleeves over the lines.
Make earth conductor connection to plug connection.
Push silicone sleeves over the lines and make electrical connection to plug connection.
Make earth connection between LED module and luminaire housing (plug connection).
Push LED plug into coupler as fa as it will go.
Assemble LED module.
Tighten the hexagon socket head cap screws evenly (4x).
Please observe that the LED module is not damaged mechanically.
Fix glass to the luminaire housing by turning it clockwise.
Make sure that gasket is positioned correctly.

Cleaning · Maintenance

Clean luminaire regularly with solvent-free cleansers from dirt.
Defective glass must be replaced.

Replacing the LED module

The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted.
The module can be replaced by qualified persons using standard tools.
Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module.
Inspect and, if necessary, replace the luminaire gaskets.
Defective glass must be replaced.
Close the luminaire.
Spares

Gantenbrink-Leuchten KG
Postfach 31 60
58689 Menden
info@bega.com
www.bega.com

References

• BEGA · Das gute Licht.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>