BEGA 50 063.1 LED Wall Luminaires Instructions
- June 13, 2024
- BEGA
Table of Contents
BEGA 50 063.1 LED Wall Luminaires Instructions
Instructions for use
Application
Wall luminaire · indoor luminaire with integrated power supply unit for many
lighting tasks in interior applications. The light emits upwards and
downwards.
Product description
- Luminaire made of aluminium alloy
- Finish Colour white
- Crystal glass with white matt finish 2 elongated fixing holes
- Width 4.5mm · 65mm spacing 1 cable entry for mains supply cable up to ø 10,5mm
- Connecting terminal 2.5@ with plug connection
- Earth conductor connection
- BEGA Ultimate Driver®
- LED power supply unit 220-240 V x 0/50-60 Hz
- DC 176-264 V
- BEGA Thermal Switch®
- Temporary thermal shutdown to protect temperature-sensitive components
- Safety class I
- Impact strength IK07
- Protection against mechanical impacts < 2 joule
- Safety mark
- Conformity mark
- Weight: 1.0 kg
- This product contains light sources of energy efficiency class(es) D
Safety
The installation and operation of this luminaire are subject to national
safety regulations. Installation and commissioning may only be carried out by
a qualified electrician. The manufacturer accepts no liability for damage
caused by improper use or installation. If subsequent modifications are made
to the luminaire, the person responsible for these modifications shall be
considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against
overvoltage in accordance with DIN EN 61547. To achieve an additional
protection against e.g. transients, etc. we recommend separate overvoltage
protection components. You can find them on our website at
www.bega.com.
Lamp
Module connected wattage : 7.6 W
Luminaire connected wattage : 9 W
Rated temperature : ta=25 °C
Ambient temperature : ta max=40 °C
50 063.1K3
Module designation: 2x LED-0276/930
Colour temperature : 3000 K
Colour rendering index: CRI > 90
Module luminous flux: 1330 lm
Luminaire luminous flux : 541 lm
Luminaire luminous efficiency : 60,1 lm/W
Installation
LED are high-quality electronic components! Please avoid touching the light output opening of the LED directly during installation or relamping. Undo the screws and lift off the luminaire top. Loosen LED plug connection. Lead the mains supply cable through the cable entry of the luminaire base. Note position of application of the luminaire “arrow down”. Fix luminaire base with enclosed or any other suitable fixing material onto the mounting surface. Be sure to use the gasket rings supplied. Make earth conductor connection. Push silicone sleeves over the lines and make electrical connection to terminal (plug connection). Make earth conductor connection between luminaire top and luminaire base. Push LED plug into coupler as fa as it will go. Install the luminaire top, press-on and manually tighten screws evenly
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt.
Replacing the LED module
The designation of the LED module is noted on a label in the luminaire. The
light colour and light output of BEGA replacement modules correspond to those
of the modules originally fitted. The module can be replaced by qualified
persons using standard tools. Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module. Inspect and,
if necessary, replace the luminaire gaskets. Defective glass must be replaced.
Close the luminaire.
Spares
LED power supply unit: DEV-0304/350
LED module 3000 K: LED-0276/930
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>