DORMAN 911-917 Engine Intake Manifold Runner Control Valve Instruction Manual
- June 1, 2024
- DORMAN
Table of Contents
DORMAN 911-917 Engine Intake Manifold Runner Control Valve
Specifications
- Product Name: 911-917 Intake Manifold Runner Control
- Manufacturer: Dorman Products, Inc.
- Model Number: 911-917
Product Usage Instructions
Installation of Steel Arms:
- Ensure two steel arms are installed correctly as shown in the diagrams provided.
- Arm 2 must be installed in the hole near the semicircular notch (refer to the second image).
- Arm 1 must be installed in the hole away from the semicircular notch.
- Align Arm 1 with the blue mark and Arm 2 with the yellow mark for proper installation.
Additional Arm Bushings:
Extra arm bushings are included in the package for replacement purposes:
- Use them to replace any existing bushings on the mating intake manifold, a common OE failure point.
- The same bushings can also be used to mate the arm to the IMRC actuator if needed.
FAQ
Frequently Asked Questions
- Q: What should I do if the steel arms are not aligning correctly with the marks?
- A: Double-check the installation steps and ensure that Arm 1 and Arm 2 are placed in the correct holes as per the provided diagrams. If alignment issues persist, contact our Technical Support team for guidance.
- Q: Can I use the additional arm bushings for other purposes?
- A: The extra arm bushings are specifically designed for replacing existing bushings on the intake manifold or mating the arm to the IMRC actuator. They should not be used for other applications.
BEFORE YOU BEGIN
- Always wear proper safety equipment when performing repairs.
- Ensure at your point of purchase that this part fits your exact vehicle configuration.
- Reference the appropriate service manual for your vehicle. If you do not have a service manual, and do not have the training or experience to perform the necessary procedures correctly, seek the services of a qualified technician.
Product Overview
Please make sure two steel arms are installed correctly as shown in diagrams. Arm 2 must be installed in hole near semicircular notch (shown in second image below), and Arm 1 must be installed in hole away from semicircular notch. Arm 1 should be aligned with blue mark and Arm 2 should be aligned with yellow mark.
Additional arm bushings are included in the package. These can be used to replace any existing bushings on the mating intake manifold, as they are a common OE failure point. The same bushings can also be used to mate the arm to the IMRC actuator, should the preinstalled ones ever need to be replaced.
Overview
NEED HELP
Please call our Technical Support team for assistance from our team of certified automotive experts. 1-866-933-2911
Disclaimer: Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
© 2022 No reproduction in whole or in part without prior written approval.