BEGA 31426 Wall Luminaire Instruction Manual

Table of Contents

The product is a wall luminaire with crystal bubble glass. It is designed for various lighting tasks in or on buildings. The luminaire is made of stainless steel and has an IP 44 protection rating. It weighs 2.2 kg and uses an E27 screw base socket.
The luminaire comes with a maximum lamp output of 60 W and has a luminaire efficiency of 45%. It is dimmable and contains a light source with an energy efficiency class E. Additional BEGA LED lamps are available for this luminaire, with detailed technical and lighting data provided in the data sheets on the manufacturer’s website.

To install the luminaire, first, loosen the screw on the luminaire arm. Remove the counter plate from the arm.
Place the luminaire arm on the counter plate, adjust it as needed, and secure it with the screw.
Loosen the screws on the luminaire roof.
Remove the roof of the luminaire and install the lamp and lamp holder.
Open the luminaire and clean it. Only use appropriate cleaning products.
Close the luminaire. Do not use a high-pressure cleaner for cleaning.

Spares

Application

Luminaire made of aluminum alloy and stainless steel
BEGA Unidure® coating technology
Crystal bubble glass
2 mounting holes ø 5.2mm
Distance apart 70mm 1 cable entry for the mains supply cable up to ø 10,5mm
Connecting terminal 2.5@ with plug connection
Earth conductor connection
Lampholder E 27
Safety class I
Protection class IP 44
Protected against granular foreign bodies ≥ 1 mm and splash water Impact strength IK02
Protection against mechanical impacts < 0.2 joule
Safety mark
Conformity mark
Weight: 2.2 kg

Safety

The installation and operation of this luminaire are subject to national safety regulations.
Installation and commissioning may only be carried out by a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or installation.
If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.

Lamp

Supplied lamp

Additional BEGA LED lamps are available for this luminaire:

13 586 LED 7 W · 805 lm · 3000 K dimmable
13 588 LED 8 W · 1055 lm · 3000 K
13 590 LED 12 W · 1400 lm · 3000 K
13 592 LED 12 W · 1400 lm · 3000 K dimmable
Detailed technical and lighting data for the lamps can be found in the data sheets on our website.

Undo the screw at the wall bracket.
Remove the mounting plate from the wall bracket.
Lead mains supply cable through the compression nipple of the mounting plate.
Note the position of application of the mounting plate »arrow down«.
Fix the mounting plate with enclosed or any other suitable fixing material onto the mounting surface.
It is absolutely essential to use the enclosed gaskets.
Make earth conductor connection and electrical connection.
Push the plug into the coupler up to the stop.
Make an earth conductor connection between the wall bracket and the mounting plate.
Place the wall bracket onto the mounting plate, adjust, and secure it with the screw.
Undo screws at the luminaire top. Lift luminaire top.
Insert lamp and assemble luminaire top.
In case a compact fluorescent lamp is used the outer lampholder sleeve can be shifted upwards to cover the lamp base completely.