BEGA 12209.1 Wall Luminaire for Indoor Use Instruction Manual
- June 13, 2024
- BEGA
Table of Contents
BEGA 12209.1 Wall Luminaire for Indoor Use
DIMENSIONS
Instructions for use
Application
Enclosed and free-radiating wall luminaire made of hand-blown opal glass, with
metal housing, for all lighting tasks in interior applications.
Product Description
Metal luminaire housing, finish Colour white Hand-blown opal glass Metal
shield, white 2 mounting holes ø 4.5mm Distance apart 138mm 2 cable entries
for through-wiring for mains cable up to ø 10.5 mm max. 3 × 1.5@ Connection
terminal 2.5@ Earth conductor connection LED power supply unit 220-240 V y
50-60 Hz BEGA Thermal Switch® Temporary thermal shutdown to protect
temperature-sensitive components Safety class I r – Safety mark c – Conformity
mark Weight: 1.1 kg This product contains light sources of energy efficiency
class(es) D
Safety
The installation and operation of this luminaire are subject to national
safety regulations. Installation and commissioning may only be carried out by
a qualified electrician. The manufacturer accepts no liability for damage
caused by improper use or installation. If subsequent modifications are made
to the luminaire, the person responsible for these modifications shall be
considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547. To achieve an additional protection against e.g. transients, etc. we recommend separate overvoltage protection components. You can find them on our website at www.bega.com.
Lamp
- Module connected wattage 7.9 W
- Luminaire connected wattage 10 W
- Rated temperature ta=25 °C
- Ambient temperature ta max=25 °C
12 209.1K3
- Module designation LED-0589/830
- Colour temperature 3000 K
- Colour rendering index CRI > 90
- Module luminous flux 1040 lm
- Luminaire luminous flux 556 lm
- Luminaire luminous efficiency 55,6 lm/W
Installation
LED are high-quality electronic components! Please avoid touching the light output opening of the LED directly during installation or relamping. Lead the mains supply cable through the cable entry into the luminaire housing. Fix the mounting plate with enclosed or any other suitable fixing material onto the mounting surface. Be sure to use the gasket rings supplied. Make an earth conductor connection. Push silicone sleeves over the lines and make electrical connection. Insert the glass into the luminaire housing and fix it by screwing the shield hand-tight clockwise onto the glass.
Cleaning · Maintenance
Clean the luminaire regularly with solvent-free cleansers from dirt. The defective glass must be replaced.
Replacement of the LED module
The designation of the LED module is noted on a label in the luminaire. The
light colour and light output of BEGA replacement modules correspond to those
of the modules originally fitted. The module can be replaced by qualified
persons using standard tools. Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module. Defective
glass must be replaced. Close the luminaire.
Spares
- Spare glass 11 003 155 .1
- LED power supply unit DEV-0177/350
- LED module 3000 K LED-0589/930
- Shield 72 000 862M
BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden · info@bega.com · www.bega.com