BEGA 89011 Ceiling and Wall Luminaire for Indoor Use Instruction Manual

Table of Contents

BEGA-89011-Ceiling-and-Wall-Luminaire-for-Indoor-Use-
product

Ensure that the product is installed and operated according to national safety regulations.
Only a qualified electrician should carry out the installation and commissioning of the luminaire.
Do not modify the luminaire unless you are authorized and responsible for those modifications.
For additional protection against overvoltage and transients, consider using separate overvoltage protection components available on the manufacturer’s website.
If you need to replace any parts, such as the glass, LED lamps (2700K or 3000K), or the lamp holder, refer to the spare part numbers provided and contact the manufacturer for assistance.

BEGA-89011-Ceiling-and-Wall-Luminaire-for-Indoor-Use-
fig-1

Application

Ceiling and wall luminaire · indoor luminaire made of hand-blown opal glass, satin matt and metal housing, for all lighting tasks.
They are ideal for places where a soft and uniform lighting distribution is required.
Luminaire with a high protection class.

Lamp

Luminaire with screw base E 27
Lamp output max. 60 W
This product contains light sources of energy efficiency class E
Supplied lamp
- BEGA LED lamp 13548
- LED Retrofit 7 W · 805 lm · 2700 K dimmable
Supplied lamp
- BEGA LED lamp 13586
- LED Retrofit 7 W · 805 lm · 3000 K dimmable
Luminaire efficiency: 64%
Detailed technical and lighting data for the lamps can be found in the data sheets on our website.

Safety

The installation and operation of this luminaire are subject to national safety regulations.
Installation and commissioning may only be carried out by a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or installation.
If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.

Overvoltage protection

The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e. g. transients, etc. we recommend separate overvoltage protection components.
You can find them on our website at www.bega.com.

Lead mains supply cable through the cable entry into the luminaire housing.
Notice position of application »arrow down« when installed at the wall.
Fix the luminaire housing with enclosed or any other suitable fixing material onto the mounting surface.
It is imperative to use the enclosed gaskets.
Make earth conductor connection.
Push silicone sleeves over the lines and make electrical connection.
Insert lamps.
Place glass to the luminaire housing and observe that the holding springbolts fit into the notches of the glass.
Turn the glass clockwise until it is locked.
Thus, you reach a safe and vibration-resistant holding of the glass.
To release the glass from the luminaire housing, turn it counter-clockwise.

Relamping /Maintenance

Disconnect the electrical installation.
To release the glass from the housing, turn it counter-clockwise.
Clean luminaire and glass.
Use only solvent-free cleansers.
Change the lamp.
The sliding-bolt closure provides a safe and vibration-resistant holding of glass.
Place glass to the housing and observe that the holding springbolts fit into the notches of the glass.
Turn the glass clockwise until it is locked.

Spares