BEGA 23256.2 Wall Luminaire Instruction Manual

: June 13, 2024
: BEGA

Table of Contents

Application
Product description
Safety
Overvoltage protection
Installation
Documents / Resources

23256.2 Wall Luminaire
Instruction Manual
Wall luminaire for indoor use

BEGA 23256.2 Wall Luminaire

Instructions for use

Application

Wall luminaire · indoor luminaire made of handblown opal glass and metal housing, for all lighting tasks in interior applications.
They are ideal for places where a soft and uniform lighting distribution is required.
Luminaire with a high protection class.

Product description

Luminaire made of Aluminium, finish Stainless steel
Hand-blown opal glass 2 elongated fixing holes
Width 6 mm · 460 mm spacing
Insulating housing with cable entry for mains supply cable up to ø 10,5 mm, max. 3 x 1,5@
Connection terminal 2.5@
Earth conductor connection
LED power supply unit 220-240 V x 0/50-60 Hz DC 176-280 V
BEGA Thermal Switch ®
Temporary thermal shutdown to protect temperature-sensitive components Safety class I
Protection class IP 44
Protected against granular foreign bodies ≥ 1 mm and splash water Impact strength IK02 Protection against mechanical impacts < 0.2 joule
Safety mark
Conformity mark
Weight: 2.2 kg
This product contains light sources of energy efficiency class(es) D

Safety

The installation and operation of this luminaire are subject to national safety regulations.
Installation and commissioning may only be carried out by a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.

Overvoltage protection

The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e. g. transients, etc. we recommend separate overvoltage protection components.
You can find them on our website at www.bega.com.

Lamp

Module connected wattage	13.4 W
Luminaire connected wattage	15.5 W
Rated temperature	ta = 25 °C
Ambient temperature	ta max = 45 °C

23 256.2 K3

Module designation	2x LED-0425/930
Colour temperature	3000 K
Colour rendering index	CRI > 90
Module luminous flux	2210 lm
Luminaire luminous flux *	1643 lm
Luminaire luminous efficiency *	106 lm / W

preliminary data
Insulation housing

Installation

For mounting and dismantling please keep a minimum distance of 350 mm between the removable cap and the wall.
LEDs are high-quality electronic components!
Please avoid touching the light output opening of the LED directly during installation or relamping.
Open luminaire:
Loosen knob, remove cap and glass.
Drill mounting holes into the mounting surface – spacing 460 mm.
For the mains supply connecting open the insulation housing – pull open – strip mains supply cable max. 15 mm and lead it into the insulation housing – see sketch.
Make earth conductor connection and electrical connection.
Connect both parts of the insulation housing until they audibly engage.
The outer coating of the cable has to be fully enclosed by the compression nipple.
Fix luminaire with enclosed or any other suitable fixing material onto the mounting surface.
Place glass into luminaire housing, close luminaire with the cap and screw in knob into the cap.

Replacement of the LED module

The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted. The module can be replaced by qualified persons using standard tools.
Disconnect the system.
Loosen lateral knob, remove cap and take out glass.
Please follow the installation instructions for the LED module.
Defective glass must be replaced.
Insert glass into luminaire housing, close luminaire with the cap and screw in knob into the cap.

Spares