BEGA 78052.1 Indoor Wall Luminaire Instruction Manual
- June 13, 2024
- BEGA
Table of Contents
**BEGA 78052.1 Indoor Wall Luminaire Instruction Manual
**
Application
Wall luminaire · indoor luminaire with integrated power supply unit for orientating lighting tasks.
Product description
Die-cast aluminium and aluminium housing, finish Stainless steel
Crystal glass, inside white 2 elongated fixing holes
Width 4.5mm · 150mm spacing 2 cable entries for through-wiring for mains
cable up to ø 10.5 mm max. 3 × 1.5@
Connection terminal 2.5@
Earth conductor connection LED power supply unit 220-240 V x 0/50-60 Hz
BEGA Thermal Control®
Temporary thermal regulation to protect temperature-sensitive components
without switching off the luminaire
Safety class I
– Safety mark
– Conformity mark
Weight: 0.7 kg
This product contains light sources of energy efficiency class(es) D
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
Installation and commissioning may only be carried out by a qualified
electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation.
If subsequent modifications are made to the luminaire, the person responsible
for these modifications shall be considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against
overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e.g. transients, etc. we recommend
separate overvoltage protection components.
You can find them on our website at www.bega.com.
Lamp
Module connected wattage 4 W
Luminaire connected wattage 4.9 W
Rated temperature ta=25 °C
Ambient temperature ta max=50 °C
78 052.1K3
Module designation 2x LED-0234/930
Colour temperature 3000 K
Colour rendering index CRI >90
Module luminous flux 610 lm
Luminaire luminous flux 404 lm
Luminaire luminous efficiency 82,4 lm/W
78 052.1 null
Module designation
Colour temperature
Colour rendering index CRI >null
Module luminous flux
Installation
LED are high-quality electronic components!
Please avoid touching the light output opening of the LED directly during
installation or relamping.
Undo the screws and lift off the luminaire top.
Lead the mains supply cable through the cable entry of the luminaire base.
Fix luminaire base with enclosed or any other suitable fixing material onto
the mounting surface.
Be sure to use the gasket rings supplied.
Make earth conductor connection.
Push silicone sleeves over the lines and make electrical connection.
Make earth conductor connection (plug connection) between luminaire top and
luminaire base.
Install luminaire top part, adjust it and tighten screws evenly.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt.
Defective glass must be replaced.
Replacement of the LED module
The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to
those of the modules originally fitted.
The module can be replaced by qualified persons using standard tools.
Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module.
Defective glass must be replaced.
Close the luminaire.
Spares
LED power supply unit DEV-0450/350
LED module 3000 K LED-0234/930
BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden · info@bega.com · www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>