BEGA 50743.4 LED Floor Lamp Instruction Manual
- June 13, 2024
- BEGA
Table of Contents
BEGA 50743.4 LED Floor Lamp
Instructions for use
Floor lamp for indoor use.
Dimension
Application
Floor lamp · indoor luminaire with impact resistant synthetic diffuser and metal housing for shielded light, deflected upwards and downwards.
Product description
Floor lamp »STUDIO LINE«
Metal housing, finish Colour velvet black
Aluminium housing shield,
Finish Colour velvet black
inside hue matt brass
Impact-resistant synthetic cover, translucent white
Foot dimmer for infinite light adjustment
Black cable · 2m, with safety plug
LED power supply unit
220-240 V 50/60 Hz
Safety class I
– Conformity mark
Weight: 13.4 kg
This product contains light sources of energy efficiency class(es) D
Safety
The installation and operation of this luminaire are subject to national safety regulations. The manufacturer accepts no liability for damage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547. To achieve an additional protection against e.g. transients, etc. we recommend separate overvoltage protection components. You can find them on our website at www.bega.com.
Lamp
Module connected wattage 43.6 W
Luminaire connected wattage 48.5 W
Rated temperature ta=25 °C
Ambient temperature ta max=50 °C
50 743.4K3
Module designation 2x LED-1227/930
Colour temperature 3000 K
Colour rendering index CRI > 90
Module luminous flux 7040 lm
Luminaire luminous flux 2953 lm
Luminaire luminous efficiency 60,9 lm/W
Installation
LED are high-quality electronic components! Please avoid touching the light output opening of the LED directly during installation or relamping.
Carefully remove the floor lamp from its packaging and set it up. Make sure
that the luminaire is in a firm and secure position.
Guide the luminaire shield provided over the synthetic cover of the luminaire
and adjust it in its end position.
Connect luminaire to mains supply (230 V).
Press foot dimmer gently to turn the luminaire on or off.
Holding the sensing device enables to adjust the light intensity infinitely.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt. We recommend that you dry-clean the foot dimmer.
Replacing the LED module
The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to
those of the modules originally fitted. The module can be replaced by
qualified persons using standard tools.
Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module.
Defective luminaire cover must be replaced. Close the luminaire.
Spares
Synthetic cover above 15 000 570
Synthetic cover below 15 000 571
LED power supply unit DEV-0338/1050
Connecting cable with foot diimmer 62 001 238
LED module 3000 K LED-1227/930
Housing shield 71 003 356 B2
Customer Support
BEGA Gantenbrink-Leuchten KG
Postfach 3160
58689 Menden
info@bega.com
www.bega.com