OttLite CSJ37G5C Clip-On LED Easel Lamp Instructions
- June 6, 2024
- OttLite
Table of Contents
OttLite CSJ37G5C Clip-On LED Easel Lamp Instructions
CONGRATULATIONS!
You’ve purchased the finest in natural lighting technology with your new OttLite ® product.
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form and return it today by mail, or register online by going to: www.ottlite.com/warranty
NOTE: THIS UNIT IS FULLY ASSEMBLED
- Remove lamp from packing.
- Grasp clamp (A) and neck to securely clamp lamp to easel or table.
- Connect adaptor (B) to lamp.
- Verify the lamp is secure before using.
- Plug adaptor (C) into a standard 120V household outlet.
- Turn the lamp ON/OFF using switch (D) located on cord
- To position the LED light assembly (E) simply bend the flex-neck as needed to point the light, ensuring clamp does not come loose.
NOTE : To avoid damaging the lamp, DO NOT force flex-neck into a sharp bend.
SAFETY WARNING : TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS
- Turn lamp off and WAIT UNTIL LAMP HEAD COOLS before handling.
- The LED panel might get hot after several hours of continuous use, DO NOT place your hands directly on LED light panel.
- Never use with an extension cord unless the plug can be fully inserted into the receptacles in the extension cord.
- Do not alter the plug.
- The lamp head included with this unit cannot be replaced by the consumer.
- INDOOR USE ONLY.
NOTE : The important safety instructions appearing in this instruction sheet are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution, and care must be used with any electrical product.
CAUTION! IF THE EXTERNAL FLEXIBLE CABLE OR CORD OF THIS LUMINAIRE IS DAMAGED, IT SHALL BE EXCLUSIVELY REPLACED BY THE MANUFACTURER OR ITS SERVICE AGENT OR A SIMILAR QUALIFIED PERSON IN ORDER TO AVOID A HAZARD. INDOOR USE ONLY.
CAUTION! THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT REPLACEABLE; WHEN THE LIGHT SOURCE REACHES ITS END OF LIFE THE WHOLE LUMINAIRE SHALL BE REPLACED.
FCC PART 15
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that the interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that of the receiver.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation
CAUTION! Any change or modification to product not expressly recognized by OttLite Technologies voids OttLite’s responsibility for proper function of product.
CAN ICES-005 (B)/NMB-005 (B)
POWER ADAPTER SPECIFICATIONS:
Input: AC 100-240V, 50/60 Hz, 0.3A
Output: 12V DC, 0.5A with a Male DC Plug
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>