BEGA 24024 Wall Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
BEGA 24024 Wall Luminaire Instruction Manual
Dimensions
Application
Shielded wall luminaire made of aluminium alloy and hand-blown three-ply opal glass. A luminaire with uniform light distribution for a variety of lighting tasks in interior and exterior lighting applications.
Lamp
- Luminaire connected wattage 14 W
- Rated temperature ta=25 °C
- Ambient temperature ta max=35 °C
24 024K3
- Module designation LED-1246/830
- Colour temperature 3000 K
- Colour rendering index Ra > 80
- Module luminous flux 1520 lm
- Luminaire luminous flux 708 lm
- Luminaire luminous efficiency 50,6 lm/W
Product description
- Luminaire made of aluminium alloy and stainless steel
- BEGA Unidure® coating technology
- Opal glass with sliding bolt glass closure 2 mounting holes ø 5.5mm Distance apart 150mm
- 1 cable entry for mains supply cable up to ø 10,5mm
- Connection terminal 2.5@
- Earth conductor connection
- LED module for power supply
- Suitable for phase angle or phase sectiondimming 220-230 V y 50/60 Hz
- BEGA Thermal Switch®
- Temporary thermal shutdown to protect
- temperature-sensitive components
- Safety class I
- Protection class IP 44
- Protected against granular foreign bodies
- ≥ 1 mm and splash water
- Impact strength IK06
- Protection against mechanical
- impacts < 1 joule
- – Safety mark
- – Conformity mark
- Weight: 2.4 kg
- This product contains light sources of energy efficiency classes F.
Safety
The installation and operation of this luminaire are subject to national safety regulations. Installation and commissioning may only be carried out by a qualified electrician. The manufacturer accepts no liability fordamage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547. To achieve an additional protection against e.g. transients, etc. we recommend separate overvoltage protection components. You can find them on our website at www.bega.com.
Installation
Lead the mains supply cable through the cable entry of the luminaire base. Notice position of use “arrow down” of the luminaire back plate. Fix luminaire base with enclosed or any other suitable fixing material onto the mounting surface. Make earth conductor connection. Push silicone sleeves over the lines and make electrical connection. Insert the opal glass into sliding bolt glass closure and turn the glass clockwise up to the stop.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt and deposits.
Do not use high pressure cleaners.
Replacing the LED module
The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted. The module can be replaced by a qualified electrician or a comparably qualified person using standard tools.
Disconnect the system and open the luminaire. Please follow the installation instructions for the LED module.
Inspect and, if necessary, replace the luminaire gaskets.
Defective glass must be replaced. Close the luminaire.
Spares
- Spare glass with graphite cap 11 002 376 S1
- Spare glass with white cap 11 002 376W1
- LED module 3000 K LED-1246/83
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>