BEGA 50 182.4 Ceiling Luminaire for Indoor Use Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
BEGA 50 182.4 Ceiling Luminaire for Indoor Use Instruction Manual
Instructions for use
Application
Ceiling luminaire · indoor luminaire with aluminium housing for non-glare
light deflected downwards.
Product description
- Ceiling luminaire »STUDIO LINE«
- Aluminium housing shield,
- Finish Colour velvet black
- inside hue matt brass
- Light-diffusing silicone lens
- Mounting plate with 2 fixing
- holes ø 4.5mm · 60mm spacing
- Connecting terminals 2.5@
- Earth conductor connection
- BEGA Ultimate Driver®
- LED power supply unit
- 220-240 V x 0/50-60 Hz
- DC 176-264 V
- Safety class I
- Safety mark
- Conformity mark
Weight: 0.3 kg
This product contains light sources of energy efficiency class(es) D
Safety
The installation and operation of this luminaire are subject to national safety regulations. Installation and commissioning may only be carried out by a qualified electrician. The manufacturer accepts no liability for damage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against
overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e.g. transients, etc. we recommend
separate overvoltage protection components. You can find them on our website
at
www.bega.com.
Lamp
- Module connected wattage 4.9 W
- Luminaire connected wattage 6 W
- Rated temperature ta=25 °C
- Ambient temperature ta max=40 °C
50 182.4K3
- Module designation LED-0689/930
- Colour temperature 3000 K
- Colour rendering index CRI > 90
- Module luminous flux 775 lm
- Luminaire luminous flux 311 lm
- Luminaire luminous efficiency 51,8 lm/W
Installation
LED are high-quality electronic components! Please avoid touching the light
output opening of the LED directly during installation or relamping.
Pull off LED cover from mounting plate.
Pass the power connecting cable through the cable entry in the mounting plate.
Fasten the mounting plate with the supplied fastening material or other
suitable fastening material to the installation surface.
Make the earth conductor connection and the electrical connection to the
terminals. Clip LED cover onto mounting plate.
Pass the enclosed housing shield over the LED cover until the housing shield
latches in place audibly
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt.
Replacement of the LED module
The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to
those of the modules originally fitted. The module can be replaced by
qualified persons using standard tools. Disconnect the system.
Pull housing shield off the mounting plate. Open the luminaire.
Please follow the installation instructions for the LED module. Close the
luminaire.
Pass the housing shield with its inner groove to the front over the LED cover
until the housing shield latches in place audibly
Spares
Shield 42 000 202 .1L 8
LED power supply unit DEV-0303/350
LED module 3000 K LED-0689/930
BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden · info@bega.com · www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>