BEGA 31203 Wall Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
**BEGA 31203 Wall Luminaire Instruction Manual
**
Instructions for use
Application
Wall luminaire for many lighting tasks on or in buildings. Ideal for places
where a soft and uniform light distribution is required.
Product description
- Luminaire made of aluminium alloy, aluminium and stainless steel
- BEGA Unidure® coating technology
- Opal glass
- Silicone gasket
- Mounting plate with 2 fixing holes ø 4.8mm · 40mm spacing 1 cable entry for mains supply cable up to ø 10,5mm
- Connection terminal 2.5@
- Earth conductor connection
- Lampholder E 14
- Safety class I
- Protection class IP 44
- Protected against granular foreign bodies ≥ 1 mm and splash water
- Impact strength IK04
- Protection against mechanical impacts < 0.5 joule
- Safety mark
- Conformity mark
- Weight: 1.6 kg
Safety
The installation and operation of this luminaire are subject to national
safety regulations. Installation and commissioning may only be carried out by
a qualified electrician. The manufacturer accepts no liability for damage
caused by improper use or installation. If subsequent modifications are made
to the luminaire, the person responsible for these modifications shall be
considered the manufacturer.
Lamp
Luminaire with screw base E 14
Lamp output max. 60 W
This product contains light source of energy efficiency class E
Supplied lamp
BEGA LED lamp 13594
LED Retrofit 4 W · 470 lm · 3000 K
Luminaire efficiency: 55%
Additional BEGA LED lamps are available for this luminaire:
13 596 LED 4,5 W · 470 lm · 3000 K dimmable
Detailed technical and lighting data for the lamps can be found in the data sheets on our website.
Installation
Undo screw at wall box and remove the mounting plate. Lead the mains supply cable through the cable entry of the mounting plate. Note position of application of themounting plate “arrow up”. Fix the mounting plate with enclosed or any other suitable fixing material onto the mounting surface. Be sure to use the gasket rings supplied. Make the earth conductor connection and the electrical connection. Make earth conductor connection between luminaire housing and mounting plate. Place the luminaire onto the mounting plate, adjust and fix it. Insert lamp. Screw glass with gasket into luminaire housing.
Relamping · Maintenance
- Disconnect the electrical installation.
- Open the luminaire and clean.
- Use only solvent-free cleaning agents. Change the lamp.
- Check the gasket and replace, if necessary.
- Close the luminaire.
- For cleaning, do not use high pressure cleaners.
Spares
Spare glass with gasket 11 002 539 41
LED lamp 3000 K 13 594
Lampholder 63 000 409
Gasket glass 83 000 672
BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden ·
info@bega.com
www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>