BEGA 51 179.6 Floor Lamp for Indoor Use Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
**BEGA 51 179.6 Floor Lamp for Indoor Use Instruction Manual
**
Instructions for use
Application
Floor lamp · indoor luminaire with metal housing and light-diffusing synthetic
disks for shielded light, deflected upwards and downwards.
Product description
Floor lamp »STUDIO LINE« Metal housing, finish Colour velvet black Aluminum
housing shield, Finish Colour velvet black inside hue matt copper Light-
diffusing synthetic disks with optical texture
Touch-controlled dimmer for infinite light adjustment Black cable · 2m, with
safety plug LED power supply unit 220-240 V y 50-60 Hz BEGA Thermal Control®
Temporary thermal regulation to protect temperature-sensitive components
without switching off the luminaire Safety class I c – Conformity mark
Weight: 4.7 kg This product contains light sources of energy efficiency
class(es) D
Safety
The installation and operation of this luminaire are subject to national safety regulations. The manufacturer accepts no liability for damage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547. To achieve an additional protection against e.g. transients, etc. we recommend separate overvoltage protection components. You can find them on our website at www.bega.com.
Lamp
Module connected wattage: 17.1 W
Luminaire connected wattage :19.5
Rated temperature: ta=25 °C
Ambient temperature ta max: =30 °C
51 179.6K3
Module designation
LED-1225/930 + LED-1224/930
Colour temperature: 3000 K
Colour rendering index : CRI > 90
Module luminous flux :2820 lm
Luminaire luminous flux: 1297 lm
Luminaire luminous efficiency: 66,5 lm/W
Installation
LED are high-quality electronic components! Please avoid touching the light
output opening of the LED directly during installation or relamping.
Carefully remove the floor lamp from its packaging and set it up. Make sure
that the luminaire is in a firm and secure position
Guide the housing shield provided over the luminaire’s light-diffusing synthetic lenses and into its end position. Connect luminaire to mains supply (230 V). The luminaire is equipped with a touchcontrolled dimmer in the middle of the upper light-diffusing lens. Press sensing device gently to turn the luminaire on or off. Holding the sensing device enables to adjust the light intensity infinitely.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt. We recommend
that you dry-clean the sensing device.
Replacing the LED module The designation of the LED module is noted on a label in the luminaire. The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted. The module can be replaced by qualified persons using standard tools. Disconnect the system and open the luminaire. Please follow the installation instructions for the LED module. Defective luminaire cover must be replaced. Close the luminaire