BEGA 23 966.2 Wall Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
**BEGA 23 966.2 Wall Luminaire
**
Dimension
Instructions for Use
Application
Ceiling mounted luminaire · indoor luminaire with handblown opal glass, satin
matt and aluminium housing, for all lighting tasks in interior applications.
They are ideal for places where a soft and uniform lighting distribution is
required.
Product Description
Luminaire made of Aluminium, finish Stainless steel
Opal glass, satin matt, with screw neck Silicone gasket
2 mounting holes ø 4.5mm
Distance apart 93mm
2 cable entries for through-wiring of mains supply cable ø 7-10.5mm
Connection terminal 2.5@
Earth conductor connection
LED power supply unit
220-240 V x 0/50-60 Hz
DC 170-280 V
BEGA Thermal Switch®
Temporary thermal shutdown to protect temperature-sensitive components
Safety class I
Safety mark
Conformity mark
Weight: 0.7 kg
This product contains light sources of energy efficiency class(es) D
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
Installation and commissioning may only be carried out by a qualified
electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation.
If subsequent modifications are made to the luminaire, the person responsible
for these modifications shall be considered the manufacturer.
Overvoltage Protection
The electronic components installed in the luminaire are protected against
overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e.g. transients, etc. we recommend
separate overvoltage protection components.
You can find them on our website at www.bega.com.
Lamp
Module connected wattage 6.1 W
Luminaire connected wattage 7.6 W
Rated temperature ta=25 °C
Ambient temperature ta max=40 °C
23 966.2K3
Module designation LED-0505/930
Colour temperature 3000 K
Colour rendering index CRI > 90
Module luminous flux 1030 lm
Luminaire luminous flux 565 lm
Luminaire luminous efficiency 74,3 lm/W
Installation
LED are high-quality electronic components! Please avoid touching the light
output opening of the LED directly during installation or relamping.
Remove glass from luminaire housing by turning it counter-clockwise.
Undo knurled screws and remove cover plate.
Lead the mains supply cable through the cable entry into the luminaire
housing.
Fasten the luminaire housing with the supplied fastening material or other
suitable fastening material to the mounting surface.
It is absolutely essential to use the enclosed protection against accidental
contact.
Make earth conductor connection.
Push silicone sleeves over the lines and make electrical connection.
Make earth conductor connection between cover plate and luminaire housing.
Assemble cover plate.
Screw glass with gasket into luminaire housing.
Make sure that gasket is positioned correctly.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt.
Defective glass must be replaced.
Replacing the LED Module
The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to
those of the modules originally fitted.
The module can be replaced by qualified persons using standard tools.
Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module.
Inspect and, if necessary, replace the luminaire gaskets.
Defective glass must be replaced.
Close the luminaire.
Spares
Spare glass 11 003 044 40RG
LED power supply unit DEV-0141/250
LED module 3000 K LED-0505/930
Gasket glass 83 001 445
Customer Support
BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden · [email protected] · www.bega.com