BEGA 51203.5 LED Pendant Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
**Technical amendments reserved
System pendant luminaire for indoor use
51 203.5
Instructions for use
**
Application
Pendant luminaire downlight · indoor luminaire with wide beam light distribution. BEGA Hybrid Optics ®: Highly efficient and low- loss light distribution, thanks to reflector and optical lens. BEGA System pendant luminaire for use in combination with various modular BEGA installation components.
Product description
Pendant luminaire downlight Cast aluminium luminaire housing, finish Colour
velvet black,
Reflector surface made of pure aluminium Optical silicone lens · BEGA Hybrid
Optics ®
Trim ring · Chrome finish Clear safety glass Black flex suspension 2 x 0,5@
Overall length of luminaire approx. 1500 mm
Safety class
**** – Conformity mark
Weight: 0.75 kg
This product contains light sources of energy efficiency class(es) F
Luminaire without canopy, for connection to an additional required BEGA
Installation component (accessory)
Lamp|
---|---
Module connected wattage| 11.1 W
Luminaire connected wattage| 14 W
Rated temperature| ta = 25 °C
Ambient temperature| ta max = 40 °C
51 203.5 K3
Module designation| LED-1150/930
Colour temperature| 3000 K
Colour rendering index| CRI > 90
Module luminous flux| 1305 lm
Luminaire luminous flux| 1120 lm
Luminaire luminous efficiency| 80 lm / W
Lighting technology
Half beam angle 37°
Safety
The installation and operation of this luminaire are subject to national
safety regulations. Installation and commissioning may only becarried out by
a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation. If subsequent modifications are made to the luminaire, the
person responsible for these modifications shall be considered the
manufacturer.
Please note:
The luminaire can only be operated with an operating device that fulfills the
requirements according to EN 61347-2-13. The maximum idle voltage of 60 V DC
must conform to SELV or SELV equivalent.
Installation
LED are high-quality electronic components!
Please avoid touching the light output opening of the LED directly during
installation or relamping.
Screw enclosed trim ring with attached reflector into the luminaire housing by
turning it clockwise.
To operate this luminaire one of the following additional BEGA Installation
components must be ordered – accessoire.
Please refer to the instructions for use for the BEGA installation component
selected for luminaire installation
Please note: The manufacturer accepts no liability for damage caused by
improper use or installation if no BEGA installation component is used
toinstall this BEGA system pendant luminaire.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt.
Replacing the LED module
The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to
those of the modules originally fitted. The module can be replaced by a
qualified person usingcommercially available tools.
Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module.
Close the luminaire.
Accessories
BEGA Installation components with LED power supply unit.
Satin black finish
Depending on the desired type of installation, the following suitable
installation components are available for this BEGA system pendant luminaire:
For all level ceilings:
13 228| Surface-mounted canopy (Type A)
on/off · 220-240 V · 350 mA DC
---|---
13 281| Surface-mounted canopy (Type AS)
Smart controllable / dimmable ·
220-240 V · 340 mA DC
Suitable for level ceilings and sloped ceilings with a pitch of 0 – 40°:
13 231| Surface-mounted canopy (Type B)
on/off · 220-240 V · 350 mA DC
---|---
13 234| Recessed canopy (Type C)
on/off · 220-240 V · 350 mA DC
13 284| Recessed canopy (Type CS)
Smart controllable / dimmable ·
220-240 V · 350 mA DC
For flush and surface-mounted 3-phase Eurostandard-Plus ® track systems:
13 221| Track adapter (Type D)
on/off · 220-240 V · 350 mA DC
---|---
For the accessories a separate instructions for use can be provided upon request.
Spares|
---|---
LED module 3000 K| LED-1150/930
Reflector| 75
Glass/Trim| 75
BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden
· info@bega.com
· www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>