BEGA 50184.6 Indoor Ceiling Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
89 759.2
Ceiling and wall luminaire for indoor use
IP 44
Instructions
for use
Application
Ceiling and wall luminaire · indoor luminaire made of hand-blown opal glass,
satin matt and metal housing, for all lighting tasks.
They are ideal for places where a soft and uniform lighting distribution is
required.
Luminaire with a high protection class.
Product description
Metal housing, finish Colour white aluminium
Hand-blown opal glass, satin matt, with sliding-bolt closure
2 mounting holes ø 5.5 mm
Distance apart 240 mm
2 cable entries for through-wiring for mains cable up to ø 10.5 mm max. 3 ×
1.5@
Connection terminal 2.5@
Earth conductor connection
Lampholder E 27
Safety class I
Protection class IP 44
Protected against granular foreign bodies
≥ 1 mm and splash water
Impact strength IK07
Protection against mechanical
impacts < 2 joule
****– Safety mark
– Conformity mark
Weight: 4.0 kg
Lamp
| Module connected wattage | 4.9 W |
|---|---|
| Luminaire connected wattage | 6 W |
| Rated temperature | ta = 25 °C |
| Ambient temperature | ta max = 40 °C |
50 184.6 K3
Module designation| LED-0689/930
Colour temperature| 3000 K
Colour rendering index| CRI > 90
Module luminous flux| 775 lm
Luminaire luminous flux| 238 lm
Luminaire luminous efficiency| 39,7 lm / W
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
Installation and commissioning may only be carried out by a qualified
electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation.
If subsequent modifications are made to the luminaire, the person responsible
for these modifications shall be considered the manufacturer.
Overvoltage protection
The electronic components installed in the \luminaire are protected against
overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e. g. transients, etc. we
recommend separate overvoltage protection components.
You can find them on our website at www.bega.com.
Installation
LED are high-quality electronic components!
Please avoid touching the light output opening of the LED directly during
installation or relamping.
Pull off LED cover from mounting plate.
Pass the power connecting cable through the cable entry in the mounting plate.
Fasten the mounting plate with the supplied fastening material or other
suitable fastening material to the installation surface.
Establish earth conductor connection and make the electrical connection to the
terminals.
Clip LED cover onto mounting plate.
Pass the enclosed housing shield over the LED cover until the housing shield
latches in place audibly.
Relamping & Maintenance
Disconnect from main supply.
Remove glass turning it counter-clockwise.
Clean glass.
Use only solvent-free cleansers.
Change the lamp.
Place glass into fitter and turn it clockwise until the stop.
Spares
| LED power supply unit | DEV-0451/350 |
|---|---|
| LED module 3000 K | LED-0518/830 |
| LED module 4000 K | LED-0518/840 |
| Gasket | 83 000 712 |
BEGA Gantenbrink-Leuchten KG
Postfach 31 60
58689 Menden
info@bega.com
www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>