BEGA 89765 Ceiling and Wall Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
89 765
IP 44
Ceiling and wall luminaire for indoor use
Instructions for use
Application
Ceiling and wall luminaire · indoor luminaire made of hand-blown opal glass,
satin matt and metal housing, for all lighting tasks. They are ideal for
places where a soft and uniform lighting distribution is required. Luminaire
with a high protection class.
Lamp
Luminaire with screw base E 27
Lamp output max. 2 × 75 W
This product contains light sources of energy efficiency class E
Supplied lamp
2 × BEGA LED lamp 13548 LED Retrofit 7 W · 805 lm · 2700 K dimmable Supplied
lamp
2 × BEGA LED lamp 13586
LED Retrofit 7 W · 805 lm · 3000 K dimmable
Luminaire efficiency: 62%
Detailed technical and lighting data for the lamps can be found in the data
sheets on our website.
Product description
Metal housing, finish colour white Hand-blown opal glass, satin matt, with
sliding-bolt closure
2 mounting holes ø 5.5 mm
Distance apart 240 mm
2 cable entries for through-wiring for mains cable up to ø 10.5 mm max. 3 ×
1.5@
Connection terminal 2.5@ Earth conductor connection
Lampholder E 27 Safety class I
Protection class IP 44
Protected against granular foreign bodies
≥ 1 mm and splash water
Impact strength IK05
Protection against mechanical impacts < 0.7 joule
– Safety mark
**** – Conformity mark
Weight: 2.8 kg
Safety
The installation and operation of this luminaire are subject to national safety regulations. Installation and commissioning may only be carried out by a qualified electrician. The manufacturer accepts no liability for damage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.
Installation
Pass the mains supply cable through the base plate.
Notice position of application »arrow down« when installed at the wall. Fix
base of the luminaire with enclosed or any other suitable fixing material on
to the mounting surface.
It is imperative to use the enclosed gaskets. Make earth and electrical
connection to the terminals.
Insert lamps.
The sliding-bolt closure provides a safe and vibration-resistant holding of
glass. Place glass to the base plate and observe that the holding springbolts
fit into the notches of the glass. Insert the opal glass into the luminaire
base with sliding bolt glass closure and turn the glass clockwise until it is
locked. To release the glass from the base plate, turn it counter-clockwise.
Relamping · Maintenance
Disconnect the electrical installation.
To release the glass from the housing, turn it counter-clockwise. Clean
luminaire and glass. Use only solvent-free cleansers. Change the lamp. The
sliding-bolt closure provides a safe and vibration-resistant holding of glass.
Place glass to the housing and observe that the holding springbolts fit into
the notches of the glass. Turn the glass clockwise until it is locked.
Spares
| Spare glass | 11 002 771 .0R G |
|---|---|
| LED lamp 2700 K | 13 548 |
| LED lamp 3000 K | 13 586 |
| Lampholder | 63 000 355 |
| Reflector | 76 000 678 |
BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden
info@bega.com
www.bega.com
Documents / Resources
| BEGA
89765 Ceiling and Wall
Luminaire
[pdf] Instruction Manual
89765, 89765 Ceiling and Wall Luminaire, Ceiling and Wall Luminaire, Wall
Luminaire, Luminaire
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>