BEGA 66960 Rectangle Wall Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
Technical amendments reserved
66 960
Lichtbaustein®
Instruction Manual
66960 Rectangle Wall Luminaire
Instructions for use
Application
Lichtbausteinb® Rectangle
Wall luminaire for corner mounting.
The luminaire is ideal for places where a soft and uniform lighting
distribution is required.
For interior and exterior applications.
Product description
Luminaire made of aluminium alloy and stainless steel
BEGA Unidure® coating technology
Opal glass satin matt
1 fixing hole ø 6.5 mm
1 cable entry for mains supply cable up to ø 10,5 mm
Lampholder terminal 2.5@
Earth conductor connection
Lampholder E 27
Safety class I
Protection class IP 44
Protected against granular foreign bodies
≥ 1 mm and splash water
Impact strength IK04
Protection against mechanical impacts < 0.5 joule
– Safety mark
****– Conformity mark
Weight: 1.4 kg
Lamp
Luminaire with screw base E 27
Lamp output max. 100 W
This product contains light source of energy efficiency class E
Supplied lamp
BEGA LED lamp 13 590
LED Retrofit 12 W · 1400 lm · 3000 K
Luminaire efficiency: 61%
Additional BEGA LED lamps are available for this luminaire:
13 584
13 586| LED 7 W · 805 lm · 3000 K
LED 7 W · 805 lm · 3000 K
dimmable
---|---
13 588
13 592| LED 8 W · 1055 lm · 3000 K
LED 12 W · 1400 lm · 3000 K
dimmable
Detailed technical and lighting data for the lamps can be found in the data sheets on our website.
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
Installation and commissioning may only be carried out by a qualified
electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation. If subsequent modifications are made to the luminaire, the
person responsible for these modifications shall be considered the
manufacturer.
Installation
Lead the mains supply cable through the cable entry into the luminaire back
housing.
For wall installation note the position of application »arrow down«.
Fix mounting plate with enclosed or any other suitable fixing material onto
the mounting surface.
It is absolutely essential to use the enclosed gasket.
Make earth conductor connection.
Push silicone sleeves over the lines and make electrical connection.
Insert lamp.
Insert the opal glass into the lower spring clips, centralise and push into
the upper spring clips.
Relamping · Maintenance
Disconnect the electrical installation.
Pull glass out of the spring clips and remove from the luminaire back housing.
Clean the glass and luminaire housing using only suitable cleansers.
When cleaning please do not use high pressure cleaners.
Change the lamp.
Snap the glass into the lower spring clips, centralise and push into the upper
spring clips.
Spares
| Spare glass | 11 002 058 .0 |
|---|---|
| LED lamp 3000K | 13 590 |
| Lampholder | 63 000 052 |
BEGA Gantenbrink-Leuchten KG · Postfach 31 60
· 58689 Menden
· info@bega.com
· www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>