CRYSTORAMA 1137-CH-CL-MWP Traditional Crystal 12 Light Chandelier Instruction Manual
- June 12, 2024
- CRYSTORAMA
Table of Contents
CRYSTORAMA 1137-CH-CL-MWP Traditional Crystal 12 Light Chandelier
Instruction Manual
WARNING:
Electrical Danger
Turn Power Off
All electrical components must be installed by a licensed electrician in
accordance with the National Electric Code and the appropriate local
electrical codes.
You will need 12- Candelabra Base Bulb40 Watts recommended 60 Watts Max. USE LED BULBS FOR EXTENDED USE
The fixture is Damp rated
HOW TO INSTALL
Place the fixture parts on a soft cloth-covered platform before installation of fixture.
- To install the 6″arms, slightly loosen each screw on the metal plate. Pull a female plug through a hole in the upper metal plate. Connect the male plug at the end of the upper arm with the female plug that was just pulled. Push the end of the arm with the metal tab through the hole until stopped by the metal tab (this should also push the wires and plugs back inside the metal plate). Twist the metal tab counter-clock wise until both inserts lock onto the loose screws. Tighten the screw securing the arm in place. Repeat for all 6″arms.
- Repeat Step 1 for the 10″ arms. The 10″ arms attaches on the bottom tier.
- Place the metal washer, beech and metal washer in that order, over the distributor box-2. Secure with the finial.
- Screw the Center column kit 1 onto the center column kit 2.
- Attach the mounting bar onto the outlet box.
- Decide the desired hanging height and adjust the chain to the correct length.
- Raise the fixture up and do the wire connection. Attach the canopy over the mounting bar and secure with collar ring.
- Dress the crystals as illustrated.
WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm. For more information go to www.p65warnings.ca.gov
Crystal Sets
A. 1 Piece. (3)14mm+(1)AS8-40mm Ball
B. 6 Sets. (1)Ring + (1)14mm + AS9-2.5″
C. 6 Sets. (1)Square + (1)14mm + AS9-2.5″
D. 6 Sets. (1)Ring + (1)Square + (7)14mm + AS9-2.5″
E. 12 Sets. (17)14mm
F. 6 Sets. (18)14mm
G. 6 Sets. (29)14mm
H. 71 Sets. (1)14mm+AS9-2″
Part Number
A. (1)-Mounting hardware Wire connector ×2. Mounting bar x1. Lock washer
×1. Hex nut ×1. Nipple ×1. Screw ×2.
B. (1)-Canopy (W5″xH1″)-XSN1130CHCAN5IN
C. (1)-Collar Ring
D. (1)-Collar Loop-XSN1130CHLOOP
E. (1)-Chain (4mmx72″)-XSN1130CHCHA4MM
F. (1)-Center Column Kit Loop
G. (1)-Center Column Kit 1
H. (6)-6″ Arms with holder-XSN500CHARM6INKD
I. (13)-Bobeche; Ø4″, 5pin,24mm center hole. -XSN1137CHBOB4IN
J. (1)-Center Column Kit 2
K. (6)-10″ Arms with holder-XSN500CHARM10INKD
L. (12)-Male Plug
M. (2)-Metal washer
N. (1)-Finial-XSN1130CHFIN
O. (12)-PVC candle sleeve ; H4
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>