CANARMNA ICH2012B04BKG15 Zelda 4 Light Matte Black and Gold Square Chandelier Instruction Manual
- June 12, 2024
- CANARMNA
Table of Contents
CANARMNA ICH2012B04BKG15 Zelda 4 Light Matte Black and Gold Square Chandelier
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS READ ALL INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS
TOOLS AND MATERIALS REQUIRED
-
Phillips Screwdriver
-
Wire Cutters
-
Pliers
-
Wrench
-
Wiring supplies as required by local electrical code
SAFETY PRECAUTIONS
- TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
- THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
- CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
- TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
INSTALLATION
-
Remove the screws from the sticks. Screw the 4 sticks onto the bottom frame.
-
Insert the square tubes over the sticks.
-
Install the top frame by tightening the 4 screws.
-
Remove the cover, hex nut and star washer from the fixture. Feed the wires from the fixture through the hole in the frame and position the fixture into the frame as shown.
-
Secure the fixture to the frame by tightening the hex nut.
-
Position the cover in place. Install the length of rod that is required by threading wire through the rod and screwing it to the fixture. Install swivel to the rod, ensuring that the sleeve is at the swivel.
-
Loosen “B”. Adjust stud to desired length and lock in place with “B”. Mount the mounting bracket to outlet box using electrical box screws (not included). Make sure the studs on the mounting bracket are facing out from the electrical box.
-
Position mounting bracket so that the fixture will be hung properly once it is mounted to the ceiling. Tighten the screw to hold in place.
-
Connect the ground wires (bare copper or green) from your fixture to the ground wire (bare copper or green) or ground screw in the electrical box. Connect the black wire (or wire with marking) from the fixture to the black wire in the electrical box and connect the white wire from the fixture to the white wire in the electrical box.
-
Once connections of wires are completed, carefully tuck wires and wire nuts into the electrical box making sure no bare wire (on the black and white) is visible at the wire nuts.
-
Position fixture over studs on mounting bracket assembly. Secure fixture in place with star washers and cap nuts.
-
Install specified bulb type and wattage (not included).
Customer Support
NEED HELP?
Call or Email us first
Our service team is ready to answer your questions….
1-800-265-1833 (English) / 1-800-567-2513 (French)
IN CANADA – ressalescanada@canarmna.ca – IN USA – ressalesusa@canarmna.ca
Monday – Friday
8AM – 5 PM E.S.T.
Tel: 613-342-5424, Fax: 800-263-4598
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>