Minka Lavery 2768-733 Silver Creek 8 Light Stone Grey Coal and Brushed Nickel Outdoor Island Chandelier Instruction Manual
- June 12, 2024
- MINKA LAVERY
Table of Contents
INSTALLATION INSTRUCTIONS
Item#2768-733 (New. 2022/04/29)
READ AND SAVE THESE INSTRUCTIONS
2768-733 Silver Creek 8 Light Stone Grey Coal and Brushed Nickel Outdoor
Island Chandelier
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARATION (Fig. 1)
-
Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
ASSEMBLING THE FIXTURE (Fig. 1)
-
Loosen hex nuts (D) on canopy (H) with wrench (J) (not included), take apart metal washer (E), lock washer (L), metal plate (I), canopy (H) and swivels (G).
-
Determine the desired hanging height and thread rods (F1, F2 and F3) to all thread (S) on fixture body. Carefully pass wires through each rod during assembly. Secure swivels (G) onto rods (F1).
-
Align canopy (H) and metal plate (I) followed by metal washer (E) and lock washer (L) onto swivels (G) and secure with hex nuts (D) via wrench (J) (not included).
-
Position mounting plate (A) on ceiling and mark the location of the two drywall anchors (K). Pre-drill holes for drywall anchors (K), then insert drywall anchors (K) into ceiling.
-
Attach mounting plate (A) to junction box (not included) using mounting screws (B) (Size: #8-32N*L0.5”) and wood screws (O) into drywall anchors (K). The side of the mounting plate marked “GND” must face out.
-
The support cable is provided to support weight of the fixture while wiring. Align fixture to mounting plate (A) and attach hook (P) on the end of support cable (R) to a slot located on mounting plate (A). Carefully allow support cable (R) to support weight of fixture while wiring.
CONNECTING THE WIRES (Fig. 2)
-
Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the green screw provided. -
Tuck wire connectors neatly into junction box.
COMPLETING THE INSTALLATION (Fig. 1) -
Align canopy (H) over mounting plate (A) and secure with screws (C).
-
Install (8) eight medium base bulbs (N) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification. — DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
-
Place glass shades (M) onto the socket cups.
Your installation is now complete. Return power to the junction box and test
the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes only.
It may or may not be identical to the fixture purchased.
LA-3561E
Documents / Resources
|
Minka Lavery 2768-733 Silver Creek 8 Light Stone Grey Coal and Brushed Nickel
Outdoor Island
Chandelier
[pdf] Instruction Manual
2768-733 Silver Creek 8 Light Stone Grey Coal and Brushed Nickel Outdoor
Island Chandelier, 2768-733, Silver Creek 8 Light Stone Grey Coal and Brushed
Nickel Outdoor Island Chandelier, Brushed Nickel Outdoor Island Chandelier,
Outdoor Island Chandelier, Island Chandelier
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>