PHILIPS 046677571160 Wall Switch Module User Manual
- June 5, 2024
- Philips
Table of Contents
PHILIPS 046677571160 Wall Switch Module
List of Items
Work on Electrical installations is in some countries only allowed by a qualified electrician. For support contact a local electrician or authority to install the product in accordance with national and electrical codes. The electrical circuit and attached light source will always be powered after installation, turn off the circuit breaker when replacing a light fixture/battery.
Wire Connectors Instructions
- Turn off power before installing or removing connectors.
- Strip wires 5/16″(7.9mm). For #16 and smaller wires, strip 3/8″(9.5mm).
- Pre-twisting unnecessary, hold stripped wires together with ends even.
- Push wires into connector and screw on until two twists are visible in wires.
For use with copper to copper conductor
Temperature Rating: 105°C (221 °F) Max.
Voltage Rating: 600V Max. building wiring; 1000V Max. in fixtures and
signs Listed as a PRESSURE-TYPE wire connector on the following Solid wire
combinations: For UL Listed, CSA Certified
Max. wire size (AWG): 22 – 10
Splice capacity: 3+ ground
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>