CRYSTORAMA HAY-1407-PN Hayes 16-Light Polished Nickel Chandelier Instruction Manual
- October 30, 2023
- CRYSTORAMA
Table of Contents
CRYSTORAMA HAY-1407-PN Hayes 16-Light Polished Nickel Chandelier
Product Information
The HAY-1407-PN is a chandelier that has been in the market for 60 years. It comes with a safety cable as it weighs over 50lbs and should be mounted to the ceiling independent of the outlet box. The product is dry rated and requires 16-Candelabra Base Bulbs, with 40 Watts recommended and 60 Watts max. The installation process requires a licensed electrician in accordance with the National Electric Code and the appropriate local electrical codes.
Product Parts
- A. (2)-Wire Connector
- B. (1)-Mounting Hardware
- C. (1)-Canopy; w5 x h1.25 (XFB1407PNCAN5IN)
- D. (1)-Collar Ring
- E. (1)-Collar Loop
- F. (1)-Chain; 72, 5mm (XFB1405PNCHA5MM)
- G. (1)-Steel Wire
- H. (1)-Ground Wire
- I. (1)-Fixture Loop
- J. (1)-Metal Tube; 9.5, 19MM thickness (XFB1407PNROD9.5IN)
- K. (1)-Threaded Pipe; 9.5, 16MM thickness (XFB1407PNSTEM9.5IN)
- L. (1)-Check Ring
- M. (1)-Metal Frame
Product Usage Instructions
- Do a complete inventory of all parts and components before you start installing.
- Screw the threaded pipe into the coupler and slide the metal tube over the threaded pipe. Slide the check ring over the top of the metal tube and secure it with a fixture loop.
- After safely attaching the fixture into the outlet box, install bulbs (not included) and proceed to connect the power.
- When you begin to dress the fixture, start with the crystal labeled (A).
- IMPORTANT: Apply crystal sets in alphabetical order.
Installation of Safety Cable
- Pass the long threaded pipe on the hickey through the center of the outlet box. Attach it to the ceiling joist and secure it with nuts.
- Feed wires and safety cable up through the chain and the hole of the screw collar loop. Have the wires and safety cable exit through the side of a hickey.
- Feed safety cable through the cable lock and coil it around the hickey twice. Then feed the cable through the lock again and tighten it with a lock screw.
- Continue to run safety cable through the top of the outlet box and secure it to the ceiling joist.
Crystal Sets
- A. 24 Sets. (1)30x400mm
- B. 40 Sets. (1)30x300mm
- C. 56 Sets. (1)30x200mm
Note:
This product can expose you to Lead, which is known to the State of California
to cause cancer and/or birth defects or reproductive harm. For more
information visit www.P65Warnings.ca.gov.
WARNING:
- Electrical Danger
- Turn Power Off
All electrical components must be installed by a licensed electrician in accordance with the National Electric Code and the appropriate local electrical codes.
You will need 16-Candelabra Base Bulb 40 Watts Recommended 60 Watts Max USE LED BULBS FOR EXTENDED USE This fixture is Dry rated.
How to Install
-
Do a complete inventory of all parts and components before you start installing.
-
Screw the threaded pipe into the coupler and slide the metal tube over the threaded pipe. Slide the check ring over the top of the metal tube and secure it with a fixture loop.
-
After safely attaching the fixture to the outlet box, install
bulbs (not included) and proceed to connect the power. -
When you begin to dress the fixture, start with the crystal labeled (A).
-
IMPORTANT: Apply crystal sets in alphabetical order.
Installation of Safety Cable
- Pass the long threaded pipe on the hickey through the center of outlet box.Attach it to the ceiling joist and secure it with nuts.
- Feed wires and safety cable up through chain and the hole of screw collar loop. Have the wires and safety cable exit through the side of hickey.
- Feed safety cable through the cable lock and coil it around the hickey twice.Then feed the cable through the lock again and tighten it with lock screw.
- Continue to run safety cable through the top of outlet box and secure it to the ceiling joist.
Crystal Sets
- A. 24Sets. (1)30x400mm
- B. 40Sets. (1)30x300mm
- C. 56Sets. (1)30x200mm
Part Number
- A. (2)-Wire Connector
- B. (1)-Mounting Hardware
- C. (1)-Canopy; w5″ x h1.25″ (XFB1407PNCAN5IN)
- D. (1)-Collar Ring
- E. (1)-Collar Loop
- F. (1)-Chain; 72″, 5mm (XFB1405PNCHA5MM)
- G. (1)-Steel Wire
- H. (1)-Ground Wire
- I. (1)-Fixture Loop
- J. (1)-Metal Tube; 9.5″, 19MM thickness (XFB1407PNROD9.5IN)
- K. (1)-Threaded Pipe; 9.5″, 16MM thickness (XFB1407PNSTEM9.5IN)
- L. (1)-Check Ring
- M. (1)-Metal Frame
- PART BAGⅠ: Includes Parts A
- PART BAGⅡ: Includes Parts B, D, E
Wiring
WARNING:
This product can expose you to Lead, which is known to the State of California
to cause cancer and/or birth defects or reproductive harm. For more
information go to www.P65Warnings.ca.gov.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>