BRAINLIT Ask, Embla Luminaires Instruction Manual
- October 30, 2023
- BRAINLIT
Table of Contents
BRAINLIT Ask, Embla Luminaires
Product Information
The product is a luminaire that requires disassembly instructions for maintenance or replacement of light sources. The luminaire has a power connection to the WAGO connectors and a driver touch protection with screw(s). The luminaire has screws on the back and a metal back plate that needs to be removed. The product also has inner layers and light sources that are glued on.
Product Usage Instructions
- Before disassembly, unplug the power connection to the luminaire by pulling apart the WAGO connectors.
- Take down the luminaire carefully.
- Unscrew the screw(s) on the driver touch protection using a screwdriver with a PH2 head. Unplug the LED cables by pressing down the cable securing button on the driver.
- Unscrew all screws on the back of the luminaire with a suitable bit and a screwdriver. To remove the metal back plate, gently pull away from the cable opening (see figure). Use gloves as edges might be sharp.
- Remove all inner layers inside the luminaire (do not discard if only replacing the light source).
- Gently peel off light sources (glued on).
- If replacing the light source, de-solder cables from light source if re-using cables, else, replace light source and cables and recycle accordingly. Remount the luminaire by following this instruction in reverse.
- Recycle all parts accordingly.
Disassembly instructions
-
STEP 1
Unplug the power connection to the luminaire by pulling apart the WAGO connectors. -
STEP 2
Take down the luminaire. -
STEP 3
Unscrew the screw(s) on the driver touch protection using a screwdriver with a PH2 head.
Unplug the LED cables by pressing down the cable securing button on the driver. -
STEP 4
Unscrew all screws on the back of the luminaire with a suitable bit and a screwdriver.
To remove the metal back plate, gently pull away from the cable opening (see figure). Use gloves as edges might be sharp. -
STEP 5
Remove all inner layers inside the luminaire (do not discard if only replacing the light source). -
STEP 6
Gently peel of light sources (glued on). -
STEP 7
Recycle all parts accordingly.
If replacing the light source; De-solder cables from light source
if re-using cables, else, replace lightsource and cables and recycle accordingly. Remount the luminaire by following this instruction in reverse