HORIZON OMEGA Z Treadmill Installation Guide
- October 30, 2023
- Horizon
Table of Contents
OMEGA Z Treadmill
Product Information: OMEGA Z Treadmill
The OMEGA Z Treadmill is a fitness equipment designed for indoor use. It is equipped with a motor that powers the running belt, which can be adjusted to different speeds. The treadmill also has an LCD display that shows the user’s speed, distance, calories burned, and heart rate (when used with a compatible heart rate monitor).
The treadmill comes with an assembly guide and a user manual that provides important precautions, safety instructions, and maintenance guidelines. The product must be grounded properly to reduce the risk of electrical shock. The user should also follow the recommended usage instructions to prevent injury or damage to the equipment.
Product Usage Instructions
- Before using the OMEGA Z Treadmill, read the TREADMILL GUIDE and ASSEMBLY GUIDE provided with the product.
- Make sure to assemble the treadmill according to the instructions provided in the ASSEMBLY GUIDE.
- Connect the treadmill to a properly grounded outlet using the provided cord and plug.
- Before stepping on the deck, make sure that the treadmill is on a flat and stable surface.
- Adjust the running belt if it is not centered or too loose/tight before use.
- Start the treadmill at a slow speed and gradually increase it to your desired level.
- If you experience chest pains, nausea, dizziness, or shortness of breath while using the treadmill, stop immediately and consult your physician before continuing.
- Do not operate the treadmill when it is folded or when there is no user on it.
- Keep children away from the treadmill and do not allow them to use it without adult supervision.
- Regularly check the treadmill for damage and wear to maintain its safety level. Contact Customer Tech Support for replacement or repair if needed.
- Clean the air opening of the treadmill regularly to prevent lint, hair, and other debris from clogging it.
IMPORTANT PRECAUTIONS
SAVE THESE INSTRUCTIONS
When using an electrical product, basic precautions should always be followed,
including the following: Read all instructions before using this treadmill. It
is the responsibility of the owner to ensure that all users of this treadmill
are adequately informed of all warnings and precautions. If you have any
questions after reading this guide, contact Customer Tech Support at the
number listed on the back panel of the OWNER’S MANUAL.
This treadmill is intended for in-home use only. Do not use this treadmill in
any commercial, rental, school or institutional setting. Failure to comply
will void the warranty.
WARNING
TO REDUCE THE RISK OF BURNS, FIRE, ELECTRICAL SHOCK OR INJURY TO PERSONS:
- Heart rate monitoring systems may be inaccurate. Over exercising may result in serious injury or death.
- When exercising, always maintain a comfortable pace.
- Do not wear clothes that might catch on any part of the treadmill.
- Always wear athletic shoes while using this equipment.
- Do not jump on the treadmill.
- At no time should more than one person be on treadmill while in operation.
- This treadmill should not be used by persons weighing more than specified in the OWNER’S MANUAL WARRANTY SECTION. Failure to comply will void the warranty.
- When lowering the treadmill deck, wait until rear feet are firmly on the floor before stepping on the deck.
- Disconnect all power before moving the equipment.
- The treadmill should never be left unattended when plugged in. Unplug from outlet when not in use, and before putting on or taking off parts.
- Do not operate under blanket or pillow. Excessive heating can occur and cause fire, electric shock, or injury to persons.
- Connect this exercise product to a properly grounded outlet only.
- If you experience any kind of pain, including but not limited to chest pains, nausea, dizziness, or shortness of breath, stop exercising immediately and consult your physician before continuing. Incorrect or excessive exercise may damage your health.
- Do not remove the protected covers unless instructed by Professional and your local dealer. Service should only be done by and authorized service technician.
- Disconnect the safety key to prevent uncontrolled usage.
- While exercising, run within the logo printed on belt to prevent possible injury.
- The noise level of the treadmill is less than 70 dB when there is no user on it and more than 70 dB when it is in use. If the noise of treadmill bothers you, stop exercising and take a break. Noise emission under load is higher than without load.
- Make sure the treadmill comes to complete stop before folding. Do not operate the treadmill when it is folded.
- Please note that the plastic parts, such as end caps, are susceptible to wear. The treadmill’s safety level can only be maintained if it is checked regularly for damage and wear.
- Make sure the edge of the belt is parallel with the side rail and does not move under the side rail. If the belt is not centered, it must be adjusted before use.
- At NO time should pets or children under the age of 13 be closer to the treadmill than 10 feet.
- At NO time should children under the age of 13 use the treadmill.
- Children over the age of 13 or disabled persons should not use the treadmill without adult supervision.
- Use the treadmill only for its intended use as described in the treadmill guide and owner’s manual.
- Do not use other attachments that are not recommended by the manufacturer. Attachments may cause injury.
- Return the unit to a service center for examination and repair.
- Keep power cord away from heated surfaces. Do not carry this unit by its supply cord or use the cord as a handle.
- Never operate the treadmill with the air opening blocked. Keep the air opening clean, free of lint, hair, and the like.
- To prevent electrical shock, never drop or insert any object into any opening.
- Do not operate where aerosol (spray) products are being used or when oxygen is being administered.
- To disconnect, turn all controls to the off position, then remove plug from outlet.
- Do not use treadmill in any location that is not temperature controlled, such as but not limited to garages, porches, pool rooms, bathrooms, car ports or outdoors. Failure to comply will void the warranty.
- This treadmill is intended for in-home use only. Do not use this treadmill in any commercial, rental, school or institutional setting. Failure to comply will void the warranty.
- Do not remove the console covers unless instructed by Customer Tech Support. Service should only be done by an authorized service a technician.
GROUNDING INSTRUCTIONS
This product must be grounded. If a treadmill should malfunction or breakdown,
grounding provides a path of least resistance for electrical current to reduce
the risk of electrical shock. This product is equipped with a cord having an
equipment-grounding conductor and a grounding plug. The plug must be plugged
into an appropriate outlet that is properly installed and grounded in
accordance with local codes and ordinances.
DANGER!
Improper connection of the equipment-grounding conductor can result in a risk
of electric shock. Check with a qualified electrician or service provider if
you are in doubt as to whether the product is properly grounded. Do not modify
the plug provided with the product. If it will not fit the outlet, have a
proper outlet installed by a qualified electrician.
This product is for use on a nominal local voltage circuit and has a grounding
plug. No adapter should be used with this product.
This product must be used on a dedicated circuit. To determine if you are on a
dedicated circuit, shut off the power to that circuit and observe if any other
devices lose power. If so, move devices to a different circuit. Note: There
are usually multiple outlets on one circuit.
WARNING!
Connect this exercise product to a properly grounded outlet only.
Never operate product with a damaged cord or plug even if it is working
properly. Never operate any product if it appears damaged, or has been
immersed in water. Contact Customer Tech Support for replacement or repair.
LOCATION OF THE TREADMILL
Place the treadmill on a level and stable surface. There should be one foot of
clearance in front of the treadmill for the power cord. Please leave a clear
zone behind the treadmill that is at least the width of the treadmill and at
least 79” (2 meters) long. This zone must be clear of any obstruction and
provide the user a clear exit path from the machine. In case of an emergency,
place both hands on the side arm rests to hold yourself up and place your feet
onto the side rails.
For ease of access, there should be an accessible space preferentially on both
sides of the treadmill equal to 2 ft (0.6 meters) to allow a user access to
the treadmill from either side.
Do not place the treadmill in any area that will block any vent or air
openings. The treadmill should not be located in a garage, covered patio, near
water or outdoors.
WARNING!
Our treadmills are heavy; use care and additional help if necessary when
moving. Do not attempt to move or transport treadmill unless it is in the
upright, folded position with the lock latch secured. Failure to follow these
instructions could result in injury.
It is essential that your treadmill is used only indoors, in a climate controlled room. If your treadmill has been exposed to colder temperatures or high moisture climates, it is strongly recommended that the treadmill is warmed up to room temperature before first time use.
ASSEMBLY
WARNING
There are several areas during the assembly process that special attention
must be paid. It is very important to follow the assembly instructions
correctly and to make sure all parts are firmly tightened. If the assembly
instructions are not followed correctly, the treadmill could have frame parts
that are not tightened and will seem loose and may cause irritating noises. To
prevent damage to the treadmill, the assembly instructions must be reviewed
and corrective actions should be taken.
Before proceeding, find your treadmill’s serial number located on the front stabilizer tube and enter it in the space provided below. Also locate the model name which is next to the serial number.
ENTER YOUR SERIAL NUMBER AND MODEL NAME IN THE BOXES BELOW:
- SERIAL NUMBER:_____
- MODEL NAME: HORIZON____ TREADMILL
TOOLS INCLUDED:
- 5 mm L-Wrench
- 6 mm T-Wrench
PARTS INCLUDED:
- 2 Console Masts
- 1 Console Assembly
- 2 Handlebars
- 1 Hardware Kit
- 1 Safety Key
- 1 Power Cord
- 1 Bottle of Silicone Lubricant
NEED HELP?
If you have questions or if there are any missing parts, contact Customer Tech
Support.
PRE ASSEMBLY
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you
place a protective covering on your floor. Take CAUTION when handling and
transporting this unit. Never open box when it is on its side. Once the
banding straps have been removed, do not lift or transport this unit unless it
is fully assembled and in the upright folded position, with the lock latch
secure. Unpack and assemble the unit where it will be used. The enclosed
treadmill is equipped with high-pressure shocks and may spring open if
mishandled. Never grab hold of any portion of the incline frame and attempt to
lift or move the treadmill.
WARNING
- DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill from packaging until specified to do so in the assembly instructions. You may remove the plastic wrap from console masts.
- FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!IMPORTANT NOTES
- During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded. It is recommended you complete the full assembly of your unit before completely tightening any ONE bolt.
- Several parts have been pre-lubricated to aid in assembly and usage. Please do not wipe this off. If you have difficulty, a light application of lithium bike grease is recommended.
- Removal of fixed guards should be done ONLY by a qualified service technician. Ensure all fasteners are properly reinstalled after replacing fixed guards.
ASSEMBLY STEP 1
Open HARDWARE FOR STEP 1.
- A Insert the CONSOLE CONTROL CABLE from the BASE FRAME through the CONSOLE MAST (RIGHT).
- B Align the CONSOLE MAST (RIGHT) to the BASE FRAME, then screw by 4 x hardware assembly (Z04+Z05+Z06).
- C Align the CONSOLE MAST (LEFT) to the BASE FRAME, then screw by 4 x hardware assembly (Z04+Z05+Z06).
ATTENTION
DO NOT PINCH THE WIRE !!
ASSEMBLY STEP 2 
Open HARDWARE FOR STEP 2.
-
A. Insert the HANDLEBAR CABLE through the hole of the CONSOLE MAST; Connect all Cables among CONSOLE, CONSOLE MAST and HANDLEBAR according to connector’s size and color; Attach CONSOLE SET onto CONSOLE MAST (RIGHT) and CONSOLE MAST (LEFT).
-
B. Attach HANDLEBAR (RIGHT) onto CONSOLE MAST (RIGHT), then screw by 4 x hardware assembly (Z04+Z05+Z07) and 4 x hardware assembly
(Z08+Z09). -
C. Attach HANDLEBAR (LEFT) onto CONSOLE MAST (LEFT), then screw by 4 x hardware assembly (Z04+Z05+Z07) and 4 x hardware assembly (Z08+Z09).
ATTENTION
DO NOT PINCH THE WIRE !!
ASSEMBLY STEP 3
- A. Assemble the SCREW COVER (RIGHT) onto CONSOLE MAST (RIGHT).
- B. Assemble the SCREW COVER (LEFT) onto CONSOLE
ASSEMBLY STEP 4
OMEGA Z
- Running Area: 140 x 53 cm / 55” x 21”
- Product Weight: 93 kg / 205 lbs.
- User Weight Capacity: 171 kg / 376 lbs.
- Dimensions (L×W×H) : 183 x 89 x 144 cm / 72” x 35” x 57”
- Folded Dimensions (L×W×H) : 103 x 89 x 169 cm /
©2022 Johnson Health Tech Made in China