KUZCO EC64810 LED Exterior Ceiling Light Instruction Manual
- June 4, 2024
- KUZCO
Table of Contents
KUZCO EC64810 LED Exterior Ceiling Light
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all times during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required
- Must be installed on a covered ceiling
- 120V input
Technical Support: 1-855-855-8926
ASSEMBLY
-
Remove fixture from its original package
Separate mounting plate (1c) from fixture body (3a) by removing set screws (2f) with allen key -
Attach mounting plate (1c) to electrical junction box (1a) using junction box screws provided (1e) in hardware package
-
Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in hardware package and place driver (4a) inside fixture body (3a)
-
Attach fixture body (3a) to mounting plate (1c) with set screws (2f) and allen key
-
For Wall Mount Only: To prevent moisture from entering the electrical junction box (1a) and causing a short, seal around the top and side perimeter between the fixture and the wall surface with weather-resistant caulking (Illustration 1). The space at the bottom should be left un-caulked to prevent moisture build-up
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>