KUZCO EP19404 LED New Lamar Outdoor Pendant Light Black Finish Installation Guide
- June 4, 2024
- KUZCO
Table of Contents
LED Exterior Pendant
EP19404
INSTALLATION SHEET
EP19404 LED New Lamar Outdoor Pendant Light Black Finish
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all times during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
Please Note:
- These Kuzco LED fixtures to come with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application
- Must be installed on a covered ceiling
- 120V input
- Remove fixture from its original package
- Separate mounting plate (1c) from the canopy (2a) by removing decorative nuts (2c)
- Align mounting plate screws (1d) to the desired orientation, and then attach a mounting plate (1c) to electrical junction box (1a) using screws provided (1e) in the hardware package
- Determine the hanging height of the fixture by securing rods (2d) to swivel (2e) and pendant body (3a)
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in the hardware package
- Align and insert mounting plate screws (1d) through holes on canopy (2a), secure with decorative nuts (2c)
- To prevent moisture from entering the outlet box and causing short, seal around the perimeter between the fixture and mounting surface with weather-resistant caulking (see illustration 1)
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20190614
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>