PDQ 6300R, 6300V Series Exit Device Instruction Manual

: October 30, 2023
: PDQ

Table of Contents

PDQ 6300R, 6300V Series Exit Device
Product Information
Product Usage Instructions
INSTALLATION
RIM DEVICE
SVR DEVICE
INSTALL BATTERY PACK
CONTACTS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PDQ 6300R, 6300V Series Exit Device

Product Information

The VIZPIN POWERED 6WS is an access control device that allows for secure entry and exit through an exit device. It can be installed on PDQ 6300R/6300V series exit devices. It comes with a control board assembly, battery pack, and battery cover. The device is powered by batteries and can be used for both left-hand (LH/LHR) and right-hand (RH/RHR) doors. For mechanical concerns, customers can contact PDQ Locks at 866-874-3662 or visit their website at www.pdqlocks.com. For electrical concerns, customers can contact VIZpin via email at Support@VIZpin.com or visit their website at www.VIZpin.com.

Product Usage Instructions

Prepare the door according to the included template.
Install the escutcheon trim onto the door while feeding the wire through the door.
If using a rim device, install the chassis/head cover. If using an SVR device, skip to step 4.
For SVR devices, install the spacer and control board assembly.
Install the battery pack by plugging the battery wire into the control board and snapping the battery pack onto the retainers on the control board assembly.
Install the batteries and battery cover with two black pan head screws.

Note: When installing the exit device, use the four included pan head screws to secure it in place.

INSTALLATION

PREPARE TRIM FOR INSTALLATION

Rotate lever to proper orientation for door, install square drive spindle into back of trim.

INSTALL TRIM AND EXIT DEVICE

Prepare door according to included template.
Install escutcheon trim onto door while feeding wire through door.
Install exit device and secure with (4) included pan head screws.
Rim Device: Install chassis/head cover.
SVR Device: Skip to step 4

RIM DEVICE

INSTALL CONTROL BOARD

Install control board assembly – feed wire through slot under circuit board.
Secure assembly with (4) included wood/ metal screws.
Make wire connection after control board is installed. Push extra wire into door cavity.

SVR DEVICE

INSTALL SPACER & CONTROL BOARD

Install rod spacer block with (2) included wood/metal screws – feed wires through slot in block.
Install top rod before control board.
Install control board assembly – feed wire through slot under circuit board and secure assembly with (4) wood/metal screws.
Make wire connections after control board installed. Push extra wire into door cavity.
Install Chassis/Head cover

INSTALL BATTERY PACK

Plug battery wire into control board.
Install battery pack over two studs on mounting plate and snap battery pack onto retainers on control board assembly.

INSTALL BATTERIES AND BATTERY COVER