PDQ 6WM Exit Device Trim Instruction Manual

October 30, 2023
PDQ

6WM/6NM Exit Device Trim
INSTALLATION INSTRUCTIONS

HAND TRIM

***** 6WM SHOWN THROUGHOUT

  • Adjust lever for proper handing

PDQ 6WM Exit Device Trim - proper handing

INSTALL MORTISE DRIVE SPINDLE

  • Install drive spindle in orientation shown
  • Place spring over installed drive spindle

PDQ 6WM Exit Device Trim - DRIVE SPINDLE

INSTALL TRIM

  • Secure trim and exit device to door
  • Trim will always thru bolt to exit device
  • Verify operation of both the trim and the exit device

CONVERSION KIT INSTRUCTIONS

  1. REMOVE BACKPLATE
    • Remove (4) screws
    • Remove backplate

  2. DETERMINE FUNCTION
    • Standard 6WM includes conversion kit within escutcheon
    • 6NM conversion kit can be ordered separatelyPDQ 6WM Exit Device Trim -
DETERMINE FUNCTION

  3. INSTALL NEW FUNCTION
    • Install desired function
    • 08 Function: Spring engages beneath boss on locking mechanism. Spring spacer must be installed on inside of spring before tightening screw
    • 09 Function: Extension spring to go around boss on locking mechanism
    • For 6WM Only: Install unneeded function into storage location
    • Reinstall backplate

PDQ 6WM Exit Device Trim - Function

639432 Rev0 – 7-7-22
Phone: 833-2-PDQTEC
www.pdqlocks.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals