PDQ 6WS 6300R, 6300V Series Exit Device Instruction Manual
- October 30, 2023
- PDQ
Table of Contents
PDQ 6WS 6300R, 6300V Series Exit Device
Product Information
The 6WS Installation Instruction is a guide for installing the PDQ 6300R / 6300V Series Exit Device with trim onto a door. The device comes in two variants, LH/LHR and RH/RHR, depending on the door’s swing direction. The installation process includes preparing the trim for installation, installing the trim and exit device, installing the control board assembly, installing the battery pack, and installing the batteries and battery cover.
Product Usage Instructions
- Prepare Trim for Installation:
- Refer to the included template and prepare the door accordingly.
- Install the escutcheon trim onto the door while feeding the wire through the door.
- Install Trim and Exit Device:
- Install the exit device and secure it with four included pan head screws.
- For Rim Device: Install chassis/head cover. For SVR Device: Skip to step 4.
- Rim Device – Install Control Board:
- Refer to the included template and install the control board assembly.
- SVR Device – Install Spacer & Control Board:
- Install the rod spacer block and control board assembly.
- Plug the battery wire into the control board.
- Install Battery Pack:
- Install the battery pack over two studs on the mounting plate.
- Snap battery pack onto retainers on control board assembly.
- Install Batteries and Battery Cover:
- Install two batteries and the battery cover with two black pan head screws.
PREPARE TRIM FOR
INSTALLATION
- Rotate the lever to the proper orientation for the door, and install a square drive spindle into the back of the trim.
INSTALL TRIM AND EXIT DEVICE
- Prepare the door according to included template.
- Install escutcheon trim onto the door while feeding the wire through the door.
- Install the exit device and secure it with (4) included pan head screws.
- Rim Device: Install chassis/head cover.
- SVR Device: Skip to step 4
RIM DEVICE – INSTALL CONTROL BOARD
- Install control board assembly – feed wire through the slot under the circuit board.
- Secure assembly with (4) included wood/metal screws.
- Make a wire connection after the control board is installed. Push extra wire into the door cavity.
SVR DEVICE – INSTALL SPACER & CONTROL BOARD
- Install rod spacer block with (2) included wood/metal screws – feed wires through slot in the block.
- Install top rod before the control board.
- Install control board assembly – feed wire through the slot under the circuit board and secure assembly with (4) wood/metal screws.
- Make wire connections after the control board is installed. Push extra wire into the door cavity.
- Install Chassis/Headcover.
INSTALL BATTERY PACK
- Plug the battery wire into the control board.
- Install the battery pack over two studs on the mounting plate and snap the battery pack onto retainers on the control board assembly.
INSTALL BATTERIES AND BATTERY COVER
- Install batteries and battery cover with(2) black pan head screws.
For Mechanical Concerns
Phone: 866-874-3662 www.pdqlocks.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>