PDQ OE-9701 GTS Electric Cylindrical Lock Instruction Manual

PDQ OE-9701 GTS Electric Cylindrical Lock

Product Information

Specifications:

• Product: GTS Cylindrical Lock
• Manufacturer: PDQ Locks
• Phone: 866-874-3662
• Website: www.pdqlocks.com

Product Usage Instructions

Check Handing of Lock
Before installation, determine the handing of the lock to ensure it is suitable for the door.

Prepare Door & Install Latch
Follow the provided template to prepare the door. Install the latch with the radius facing towards the door frame and secure it with two small combo screws.

Install Chassis and Outside Trim
Proceed to install the chassis and outside trim components as per the provided instructions.

Install Inside Escutcheon
Secure the inside escutcheon using two pan head screws.

Install Batteries and Inside Lever
Insert batteries into the designated compartment and install the inside lever accordingly.

Handing Instructions
If required, rotate the inside rose plate and chassis to match the hand of the door. Follow these steps:

1. Remove rose plate mounting screws and the rose plate.
2. Unplug the motor connector and feed it through the wire chase slot on the other side.
3. Re-connect the motor connector.
4. Rotate the rose plate to index with the chassis (arrows point to latch bolt edge of the door).
5. Install the rose plate and secure it with mounting screws.

FAQ (Frequently Asked Questions)

Q: What should I do if the lock is not functioning properly after installation?
A: If you encounter any issues with the lock’s functionality,please refer to the troubleshooting section in the user manual or contact our customer support for assistance.

Q: Can I use rechargeable batteries with this lock?
A: It is recommended to use standard non-rechargeable batteries with this lock for optimal performance.

GTS INSTALLATION INSTRUCTION
CYLINDRICAL LOCK

CHECK HANDING OF LOCK

• If handing of lock is not correct for opening, see next page for handing instructions.

PREPARE DOOR & INSTALL LATCH

• Prepare door according to template.
• Install latch, radius toward door frame
• Secure with (2) small combo screws.

INSTALL CHASSIS AND OUTSIDE TRIM

• Remove inside escutcheon from backplate
• Install chassis assembly from inside of door.
• Install outside trim assembly – feed reader wire through hole and door and through slot under circuit board. Plug into board. Push extra wire into door cavity.
  • Wire harness will land into wire pocket.
  • Refer to image for location.
• Secure with (2) flat head screws (thru bolts).

INSTALL INSIDE ESCUTCHEON

• Install inside escutcheon.
• Secure with (2) pan head screws.

INSTALL BATTERIES AND INSIDE LEVER

• Install batteries and battery cover with flat head screw.
• Install inside lever and secure with dog point set screw.
• CAUTION: DO NOT CROSS THREAD

HANDING INSTRUCTIONS

AS REQUIRED, ROTATE INSIDE ROSE PLATE AND CHASSIS TO MATCH HAND OF DOOR.

TO ROTATE CHASSIS:

1. Remove rose plate mounting screws, then rose plate.

2. Unplug motor connector. Feed motor connector and wire back through wire chase slot.

3. Rotate chassis 1/2 turn (180°) maximum.

4. Feed motor connector and wire forward through wire chase slot on other side.
   Re-connect motor connector.

5. Rotate rose plate to index with chassis. (Arrows point to latch bolt edge of door.)

6. Install rose plate, secure with mounting screws.

Phone: 866-874-3662
www.pdqlocks.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>