PDQ 9300 Series Mullion Instructions

October 30, 2023
PDQ

PDQ 9300 Series Mullion

ROUTE FEMALE HARNESS THROUGH TOP BRACKET

  • Ensure wire tubing routes through hole in top of bracket and through the two 3/16″ spring pins.
  • Wire from building to be connected by butt connector, supplied by installer, to female harness.
  • Follow mullion installation instructions.
    Route Female Harness Through Top Bracket

INSTALL MULLION TUBE

  • Carefully connect wire from female harness to bracket and push tube onto top bracket – allowing any extra wire to land in tube.
  • Male wiring harness to be connected to additional wire (supplied by installer) to reach strikes.
    Install Mullion Tube

INSTALL BOTTOM BRACKET

  • Install bottom bracket parallel with wall, 1.75″ from the edge.
  • Angled face to be on the same side as the back of the mullion to allow for removal of tube.
    Install Bottom Bracket

INSTALL TOP BRACKET

  • Place the mullion tube (not included in storage kit) on top of the bottom bracket.
  • Place the top bracket on top of the tube.
  • Hold the mullion plumb, then mark for two holes on the wall.
  • Drill holes at the marked location for appropriate wall condition (fasteners not supplied)
  • Remove mullion from storage bracket with screwdriver.
    Install Top Bracket

CUSTOMER SUPPORT

Phone: 833-2-PDQTEC | www.pdqlocks.com

PDQ Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals