Kruger Matz KM0563 Wireless Speaker Owner’s Manual

: October 30, 2023
: Kruger Matz

Table of Contents

SAFETY INSTRUCTION
DESCRIPTION
OPERATION
SPECIFICATION
LEARN MORE
Documents / Resources

Kruger Matz KM0563 Wireless Speaker Owner’s Manual

SAFETY INSTRUCTION

Place the device on flat, stable surface.
Do not place heavy objects on the device.
Do not place anything in speakers interior.
Do not place the device in close proximity to heat sources, such as radiators etc. Do not place the device on unstable surfaces.
Position the device in a properly ventilated place. Do not obstruct ventilation by covering ventilation openings.
Protect this device from humidity, water and other liquid. Avoid using/storing it in extreme temperatures. Do not expose it to direct sunlight and other sources of heat.
Before connecting the device to power supply socket, make sure the voltage indicated on the appliance corresponds to the voltage in the power supply socket.
Keep the volume at a reasonable level throughout entire time of using the speaker. To prevent damage to your hearing, do not raise the volume too high.
If you experience tinnitus, discomfort or other concerning behaviors, stop using the device immediately.
Make sure, that the device is placed away from electrical devices that generate interference.
Disconnect from power outlet if the device is not going to be used for a long time.
Do not handle this device with wet hands.
Do not use this device if it has been damaged.
Do not attempt to repair this device yourself. In case of damage, contact authorized service point for check-up or repair.
Always disconnect the product from the power source before cleaning.
Clean this device with a soft, slightly damp cloth. Do not use any chemical agents to clean this device.

DESCRIPTION

Description

USB-C charging port
AUX 3,5 mm input
USB port
Volume up / down / change track buttons
Microphone
Play / pause button
Mode button
Power button

OPERATION

Turning on / off / volume adjustment

To turn on the speaker, press and hold power button for about 2 seconds. To turn off the speaker, repeat this action. To increase or decrease the volume keep pressing volume up/ down button until the desired value is reached.

Illumination settings

The speaker illumination turns on automatically when you turn on the device. To change light effects or turn them off press and hold play / pause button.

Playing via Bluetooth

The speaker will automatically go to Bluetooth mode, after turning it on. On the external device, search for Bluetooth devices and connect to the speaker (KM Street). Played music can be controlled on the external device or with the buttons on the speaker. Press and hold the volume up button to change the track. To play the previous track, press and hold the volume down button.

Playing via USB

After plugging the USB drive, the speaker will automatically go to USB mode. To control played music, use buttons on the speaker. Press and hold the volume up button to change the track. To play the previous track, press and hold the volume down button.

Playing via AUX

When connected to the AUX jack, the speaker will automatically enter AUX playback mode. Use your source device to control the music that is playing.

TWS function

TWS function allows for playing from one source on two speakers. After turning on the speakers, press and hold mode button on the one of them. Correct pairing will be signaled by the voice prompt. After connecting the external device, the sound will be played on both speakers. To turn of TWS mode, press and hold mode button again.

Hands-free features

To answer a phone call on the loudspeaker, press the play / pause button. During a call, press and hold the play/pause button for about 2 seconds to switch the call to the phone.

Charging

The low battery level will be indicated by the flashing LED indicator and by voice prompt. To charge the speaker, connect the plug of the mains charger to the speaker charging USB-C port, and the charger itself should be connected to a mains socket. While charging, charging indicator will be flashing. When the device is fully charged, charge indicator will be off. Low battery status will be indicated by voice prompt.

Resetting the device

If the speaker does not respond to the buttons, the device can be reset using the button located in the AUX port. Press it down using a narrow object.

SPECIFICATION

Power: 20 W
Impedance: 3 Ohm
Frequency response: 80 Hz – 16 kHz
S/N ratio: ≥85 dB
Drive units: 2x 2″
Bluetooth: 5.0
Bluetooth range: up to 10 m
Bluetooth profile: A2DP/AVRCP/HFP
Supported formats: MP3/WAV/WMA/FLAC
TWS function (connect two speakers)
RGB backlight
Protection class: IPX5
I/O:
• USB 2.0 port
• AUX input (Jack 3,5 mm)
• USB-C port (charging)
Power supply: 5 V / 1 A
Battery: 3,7 V / 2000 mAh
Dimensions: 242 x 92 x 92 mm
Weight: 0,75 kg
In set: USB-C cable, 3,5mm AUX cable, lanyard, user manual

Lechpol Electronics Sp. z o.o. Sp.k. hereby declares that Wireless speaker KM0563, KM0564, KM0565 are consistent with directive 2014/53/UE.

Full text of the EU Declaration of Conformity is available at following Internet address: www.lechpol.pl.

LEARN MORE

For more information on this device visit: www.krugermatz. com.
Read owner’s manual carefully before using.
Visit www.krugermatz.com website for more products and accessories.
In case of any doubts or questions reach out to our Frequently Asked Questions section.

Correct Disposal of This Product (Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal.

**Symbols

**

www.krugermatz.com