Kruger Matz KM0566 Street XL Wireless Speaker Owner’s Manual

: October 30, 2023
: Kruger Matz

Table of Contents

SAFETY INSTRUCTION
DESCRIPTION
OPERATION
SPECIFICATION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Kruger Matz KM0566 Street XL Wireless
Speaker Wireless speaker
KM0566
KM0567

SAFETY INSTRUCTION

Place the device on flat, stable surface.
Do not place heavy objects on the device.
Do not place anything in speakers interior.
Do not place the device in close proximity to heat sources, such as radiators etc. Do not place the device on unstable surfaces.
Position the device in a properly ventilated place. Do not obstruct ventilation by covering ventilation openings.
Protect this device from humidity, water and other liquid. Avoid using/storing it in extreme temperatures. Do not expose it to direct sunlight and other sources of heat.
Before connecting the device to power supply socket, make sure the voltage indicated on the appliance corresponds to the voltage in the power supply socket.
Keep the volume at a reasonable level throughout entire time of using the speaker. To prevent damage to your hearing, do not raise the volume too high.
If you experience tinnitus, discomfort or other concerning behaviors, stop using the device immediately.
Make sure, that the device is placed away from electrical devices that generate interference.
Disconnect from power outlet if the device is not going to be used for a long time.
Do not handle this device with wet hands.
Do not use this device if it has been damaged.
Do not attempt to repair this device yourself. In case of damage, contact authorized service point for check-up or repair.
Always disconnect the product from the power source before cleaning.
Clean this device with a soft, slightly damp cloth. Do not use any chemical agents to clean this device.

DESCRIPTION

Kruger Matz KM0566 Street XL Wireless Speaker -
DESCRIPTION

Volume adjustment / change track buttons
Play / pause button
Power button
Mode button
TWS function button
Illumination change button
Microphone
USB port
AUX 3,5 mm input
USB-C charging port
Reset button

OPERATION

Turning on / off / volume adjustment
To turn on the speaker, press and hold power button for about 2 seconds. To turn off the speaker, repeat this action. To increase or decrease the volume keep pressing volume up/down button until the desired value is reached.
Illumination settings
The speaker illumination turns on automatically when you turn on the device. To change light effects or turn them off, keep pressing illumination button.
Playing via Bluetooth
The speaker will automatically go to Bluetooth mode, after turning it on. On the external device, search for Bluetooth devices and connect to the speaker (KM Street XL). Played music can be controlled on the external device or with the buttons on the speaker.
Playing via USB
After plugging the USB drive, the speaker will automatically go to USB mode. To control played music, use buttons on the speaker.
Playing via AUX
After connecting to the AUX socket, the speaker will automatically enter AUX playback mode. Use your source device to control the music that is playing.
FM radio
To switch to the FM radio, press the play mode change button until the desired mode is selected. Press and hold the play/ pause button to search and automatically store available radio stations. Pressing this button briefly mutes the sounds. To switch between saved stations, press and hold one of the volume/track buttons.
TWS function
TWS function allows for playing from one source on two speakers. After turning on the speakers, press TWS button on the one of them. Correct pairing willbe signaled bythe blinking ofthe LED next to the TWS function button. After connecting the external device, the sound will be played on both speakers. To turn off TWS mode, press TWS button again.
Voice assistant and hands-free features
After connecting the phone to the speaker via Bluetooth, while in this mode, you can launch the voice assistant of the phone, if available. To do this, press and hold the play/pause button for about 2 seconds. To answer a phone call on the loudspeaker, press the play / pause button. During a call, press and hold the play/pause button for about 2 seconds to switch the call to the phone.
Charging
The low battery level will be indicated by the flashing LED indicator and by voice prompt. To charge the speaker, connect the plug of the included mains charger to the speaker charging USB-C port, and the charger itself should be connected to a mains socket. While charging, LED indicator will be flashing. When the device is fully charged, LED indicator will be lit still.

SPECIFICATION

Power: 30 W
Impedance: 4 Ohm
Frequency response: 80 Hz – 20 kHz
S/N ratio: 80 dB
Drive units: 2x 3″
Bluetooth: 5.0
Bluetooth range: up to 10 m
Bluetooth profile: A2DP/AVRCP/HFP
Supported formats: MP3/WAV/WMA/FLAC
FM radio
FM frequency: 87,5 MHz – 108 MHz
TWS function (connect two speakers)
RGB backlight
Protection class: IPX5
I/O:
USB 2.0 port
AUX input (Jack 3,5 mm)
USB-C port (charging)
Power supply: 5 V / 1,5 A
Battery: 3,7 V / 3000 mAh
Dimensions: 295 x 120 x 122 mm
Weight: 1,6 kg
In set: USB-C cable, 3,5mm AUX cable, strap, user manual

Lechpol Electronics Sp. z o.o. Sp.k. hereby declares that Wireless speaker KM0566, KM0567 are consistent with directive 2014/53/UE.
Full text of the EU Declaration of Conformity is available at following Internet address: www.lechpol.pl.
LEARN MORE
For more information on this device visit: www.krugermatz.com.
Read owner’s manual carefully before using.
Visit www.krugermatz.com website for more products and accessories.
In case of any doubts or questions reach out to our Frequently Asked Questions section.

Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources.
Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal.
Made in China for Lechpol Electronics Leszek Sp.k., ul. Garwolińska 1, 08-400 Miętne.

Kruger Matz KM0566 Street XL Wireless Speaker - qr
code www.krugermatz.com
is a registered trademark