ESPEN TECHNOLOGY VC720MV Switch Charger User Manual
- June 6, 2024
- ESPEN TECHNOLOGY
Table of Contents
ESPEN TECHNOLOGY VC720MV Switch Charger
Amaz247 ARC80 Point Anywhere WiFi Remote Control
Product Parameter
- Name： Switch charger
- Model： VC720MV
- Input： AC 120-277V，50-60Hz
- Operation frequency：110-208kHz
- Modulation Type： ASK
- Antenna Gain：0 dBi
Note: The above parameters are derived from the actual measurement of the product, the actual parameters will vary due to the product or other factors.
Instructions
- The blue LED indicator light will be on after power-on.
- Put on the wireless receiving device that supports, enter the charging state after the product is aligned
- When wireless charging encounters a metal foreign body, the wireless charger will automatically activate the FOD foreign body alarm function, and the indicator light will flash quickly, remove the metal foreign body, you can charge normally.
Matters needing attention
-
It is recommended to use a high-power adapter with18W the above for a better experience.
-
Please try to avoid placing metal objects on the contact surface during charging, such as patches, finger rings, metal protective shells, etc.
-
If you find intermittent charging or severe heating while charging, it is likely that the receiving coil of the wireless charging coil are not accurately aligned, and then perform the correct position alignment.
-
This product has input over-current and over-voltage protection function, if improper use will shut down or reduce the output power, please check whether the equipment is abnormal or improper use.
-
When using, keep the ambient temperature at -20 to 55℃
as much as possible. Please avoid putting the product in water, fire, high (>55℃) and too low temperature (<-20℃) environment, and keep children away from accessories. -
Please use a dry soft cloth to clean the surface and avoid cleaning with chemicals, soap or detergent.
-
The user’s improper use or improper placement of this product may cause the product’s life to be reduced or damaged, and the resulting liability does not belong to the scope of the warranty or the manufacturer’s responsibility, please understand.
FCC Statement
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However,there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>