Kruger Matz KM0819 Portable Radio User Manual

: June 3, 2024
: Kruger Matz

Table of Contents

SAFETY INSTRUCTIONS
OPERATION
SPECIFICATION
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

IT’S YOUR LIFE, JUST TAKE IT
Portable radio
KM0819
USER’S MANUAL

SAFETY INSTRUCTIONS

Read the entire instruction manual before you start installation and assembly and keep it for future reference.

Protect this device from humidity, water and other liquid.
Before connecting the device to power supply socket, make sure the voltage indicated on the appliance corresponds to the voltage in the power supply socket.
Position the device in a properly ventilated place.
Protect the device from heat sources and extreme temperatures.
Clean the device with a soft, slightly damp cloth.
Do not use any chemical agents to clean this device.
Disconnect the device from power outlet, if it is not going to be used for a long time. Store the device without the batteries inside.
Never disassemble this device. In case of damage, contact the authorized service point for a repair.
Do not store magnet sensitive items near the device.

PRODUCT DESCRIPTION

Antenna
Display
Earphone jack
Tuning buttons
ON/OFF button
BAND/ALARM button
P+ / P- buttons
Function button
SET button
Volume buttons

OPERATION

Battery installation

Open the battery compartment on the back of the device.
Insert the batteries (note the correct polarity).
Close the battery compartment cover.

Turning on/off
To turn the radio on or off, press the ON/OFF button.
Tuning stations

After turning the radio on, the frequency will be shown on the display.
To change the band from FM to AM, press the BAND button.
To set the frequency, use the tuning buttons.
To set the frequency automatically, press and hold one of the tuning buttons for 2 seconds. The station with the strongest signal will be set.
While listening to the radio, pressing the function button will turn on the stereo function. If the signal strength is weak, turn off the stereo function (stereo function only works with stereo headphones).

Saving stations
To save the station:

Set the frequency.
Press the SET button. A flashing number will appear on the display to indicate channel selection.
Press the P+ or P- button to select the channel where you want to store the radio station.
Press the SET button to save the station.
If the SET button is not pressed after 3 seconds, the radio station will be stored on the last selected channel.

To scan and store all found radio stations, press and hold the SET button for 5 seconds. The SCAN icon will flash on the display.
Setting the clock

Turn off the radio.
Make sure that the alarm function is turned off (there is an alarm icon on the display, press thBAND/ALARM button).
Press the SET button. Select 12 or 24 hour system with the tuning buttons. Confirm with the SEbutton.
Set the hour with the tuning buttons. Confirm witthe SET button.
Set the minutes with the tuning buttons. Confirm with the SET button.

Setting the alarm

Turn off the radio.
Press the SET/ALARM button to turn on the alarm.
Press the SET button to set the hour of the alarm.
Use the tuning buttons to set the hour. Confirm with the SET button.
Use the tuning buttons to set the minutes. Confirm with the SET button.
Use the tuning buttons to set the alarm sound: rad (radio) or buz (buzzer). Confirm with the SET button.
Once the alarm time is set, it can be turned off using the SET/ALARM button.
If you have selected the radio as your alarm tone, the last station you were listening to will play during the alarm at the last selected volume level.
After activation of the alarm, you can set the 10 minute snooze. To do this, press the BAND button.
To turn off the alarm while the snooze is activated, press the ON/OFF button.
To turn off the alarm after it has been activated, press the ON/OFF button.

Setting the timer
The radio can turn off after set amount of time. To do this:

Turn off the radio.
Press and hold the ON/OFF button until the display shows the SLEEP icon and the number 90, indicating the time until shutdown (in minutes).
Keep pressing the ON/OFF button until you reach the desired time. After setting the time, the radio will turn on automatically and turn off after the set time.
To turn off the timer function, press the ON/OFF button.

Lock function
To turn on the lock, press and hold the function button for 2 seconds. The key icon will appear on the display. While the lock is enabled, all the buttons are inactive. To disable the lock function, press and hold the function button for 2 seconds.

SPECIFICATION

20 stations memory
Clock
Alarm function
Headphone jack (3,5 mm)
Telescopic antenna
Radio frequency:
AM: 522 – 1620 kHz
FM: 87,5 – 108 MHz
DC power supply: 3 V (2x AAA battery)

Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling.
Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal.

http://www.krugermatz.com/
is a registered trademark

Made in China for LECHPOL ELECTRONICS
Sp. z o.o. Sp.k., ul. Garwolińska 1, 08-400 Miętne.