Eterna TWSRCDMC Twin Unswitched AC Rated RCD Socket Instruction Manual
- June 10, 2024
- Eterna
Table of Contents
Eterna TWSRCDMC Twin Unswitched AC Rated RCD Socket Instruction Manual
READ THIS FIRST:
Check the pack and make sure you have all of the parts listed on the front of
this booklet. If not, contact the outlet where you bought this product.
This fitting must be installed by a competent person in accordance with the
Building Regulations making reference to the current edition of the IEE Wiring
Regulations (BS7671).
As the buyer, installer and/or user of this product it is your own
responsibility to ensure that this spur or socket is fit for the purpose for
which you have intended it. Eterna Lighting cannot accept any liability for
loss, damage or premature failure resulting from inappropriate use.
Suitable for indoor use only.
Do not attach to surfaces which are damp, freshly painted or otherwise
electrically conductive (e.g. metallic surfaces).
Make connections to the electrical supply in accordance with the following
code:
Live – Brown or Red Neutral – Blue or Black Earth – Green and Yellow
When making connections, ensure that the terminals are tightened securely and
that no strands of wire protrude. Check that the terminals are tightened onto
the bared conductors and not onto any insulation.
This product must be connected to Earth.
You are advised at every stage of your installation to double-check all
electrical connections you have made. After you have completed your
installation there are electrical tests that should be carried out: these
tests are specified in the Wiring Regulations (BS7671) referred to in the
Building Regulations.
INSTALLATION:
SINGLE FUSED RCD SPUR
Connect the wiring from the mains supply to the terminals marked “LINE”. See
diagram opposite.
Connect the wiring from your appliance to the terminals marked “LOAD”. See
diagram opposite.
TWIN UNSWITCHED RCD SOCKET
Connect your mains supply wiring to the terminals according to the colour code
above. Note that earth connections may be made to either or both terminal(s)
marked “E”. See diagram opposite.
OPERATION:
- Restore the mains power (after installation).
- Press the green reset button and check that the indicator window has turned red.
- (For every use) Press the TEST button.
- Check that the indicator window has turned white.
- Press the reset button and use as a normal socket.
SPECIFICATION:
- Maximum operating load: 13A resistive, 3A inductive.
- Mechanically latched (no need to reset after power loss).
- Responsive to both positive and negative cycles.
- Trip speed less than 40ms.
- 30mA trip current.
- RCD contact break: double pole.
NOTE: unit will trip if the live and neutral input is reversed and if neutral and/or earth connections are lost. The unit will also react to pulsating earth fault currents.
EVENTUALLY, YOU MAY WANT TO REPLACE THIS PRODUCT:
Regulations require the recycling of Waste from Electrical and Electronic Equipment (European “WEEE Directive” effective August 2005–UK WEEE Regulations effective 2nd January 2007). Environment Agency Registered Producer: WEE/ GA0248QZ.
WHEN YOUR PRODUCT COMES TO THE END OF ITS LIFE OR YOU CHOOSE TO REPLACE IT, PLEASE RECYCLE IT WHERE FACILITIES EXIST – DO NOT DISPOSE WITH HOUSEHOLD WASTE.
CLEANING:
Clean this fitting only with a soft dry cloth.
Do not use any chemical or abrasive cleaners.
IF YOU EXPERIENCE PROBLEMS:
If you believe your product is defective, please return it to the place where you bought it. Our Technical Team will gladly advise on any Eterna Lighting product, but may not be able to give specific instructions regarding individual installations.
Email: sales@eterna-lighting.co.uk / technical@eterna-lighting.co.uk
Visit our website: www.eterna-lighting.co.uk
Made in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>