anslut 423927 Lamp Post Instruction Manual

June 4, 2024
anslut

anslut 423927 Lamp Post logo

anslut 423927 Lamp Post

anslut 423927 Lamp Post
product

SAFETY INSTRUCTIONS

Read the operating instructions carefully before use.
Save them for future reference.
WARNING: Check that the power supply is disconnected prior to installation.

  • The product can not be used as street lighting.
  • The bulb gets hot when it is switched on. Do not touch the bulb until it has cooled.
  • Disconnect the power supply and allow the bulb to cool before changing.
  • Never use bulbs with a higher output power than that specified in the technical data.
  • Never use the product if the protective cover or glass is damaged or cracked. Replace defective parts as soon as possible.
  • Never look directly at the light source.
  • The earth wire must always be connected.
  • Use wires with a cross sectional area of at least 1 mm2
  • Use a 2-way switch.

ELECTRICAL SAFETY

New installations and extensions to existing installations should always be carried out by an authorised electrician. If you have the necessary experience and knowledge (otherwise contact electrician), you may replace switches and power points, fit plugs, extension cords and light sockets. Incorrect installation can result in electric shock or fire.

TECHNICAL DATA

  • Rated voltage 230 V ~ 50 Hz
  • Protection rating IP44
  • Socket base 3x E27
  • Max. output (light source) 60W
  • Height 220 cm

INSTALLATION

WARNING: Check that the power supply is disconnected prior to installation. Follow the instructions below.

Install according to steps 7-6 below.anslut 423927 Lamp Post fig
1

MAINTENANCE

Treat with acid-free oil, for example, WD-40, 3-4 times per year. We do not recommend the use of stainless steel luminaires in exposed and corrosive environments.

Changing the bulb
IMPORTANT: Disconnect the power supply before changing the bulb.

  1. Remove the top cover.
  2. Allow the bulb to cool and then screw it out carefully (do not touch the bulb with your bare hands).
  3. Carefully screw in the new bulb.
  4. Fit the upper cover before reconnecting the power supply.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals