GP CR42 Rechargeable Outdoor Flashlight Instruction Manual
- June 8, 2024
- GP
Table of Contents
GP CR42 Rechargeable Outdoor Flashlight
Operating instructions
Charging/changing battery
- Unscrew the tail cap (A)
- Ensure Li-ion 18650 battery inserted correctly in battery holder
- Plug the Micro USB end into the flashlight. Plug the USB end into a power source such as a computer, power bank charger, USB wall socket adapter or USB car charger
- LED indicator light:
- Green LED: Charging completed
- Red LED: Charging in progress
- Disconnect the USB cable when fully charged and screw tail cap (A) to a flashlight
- In the event you want to change the battery unscrew the charging base (B) and remove discharged battery
- Replace with charged battery taking care to install according to polarity markings +/- and replace charging base (B)
- Screw on tail cap securely
Operation
- Full press switch on tail cap for On/Off
- Full press switch -> High -> Half press switch -> Medium -> Half press switch -> Low
- Half-press switch -> Eco -> Half press switch -> SOS (Half press to cycle repeats)
- Alternatively full press On and Off -> cycle repeats
Safety Instructions and Warnings
Use the device in a temperature range between 0 and 40°C and avoid exposure
to direct heat and constant sunlight. This appliance is not intended for use
by young children or inform persons unless they have been adequately
supervised by a responsible person to ensure that they can use the appliance
safety. Young children should be supervised to ensure that they do not play
with the appliance. Do not cover the headlamp or place face down on a surface
when the light is switched on
Batteries
Use 1 x GP Li-ion 18650 battery with integrated overcharge and over-discharge Protection Circuit Module (PCM). Failure to use dedicated GP Li-ion 18650 batteries for the application device may result in damage to the flashlight and/or batteries. Users may experience risks if damaged or short-circuited cells are installed. Risk of fire and burns. Do not recharge, disassemble, heat above 40°C, or incinerate. Keep the battery out of reach of children and in original package until ready to use. Dispose of used batteries promptly.
Replacing batter y When changing batteries first switch off the flashlight before removing tail cap (A) and install new batteries in the appropriate battery holder. Screw the tail cap when batteries have been correctly fitted according to the prescribed polarity markings on the battery holder (+) and (-). Care should be taken that the batteries are installed in accordance with the battery polarity.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>