anslut 013881 Tower Fan Instruction Manual
- June 3, 2024
- anslut
Table of Contents
anslut 013881 Tower Fan
SAFETY INSTRUCTIONS
- Only intended to be used indoors.
- This product can be used by children from eight years and upwards and by persons with physical, sensorial or mental disabilities, or persons who lack experience or knowledge if they are supervised or receive instructions concerning the safe use of the product and understand the risks involved with its use. Do not allow children to play with the product.
- The product must only be used for its intended purpose and in accordance with these instructions.
- Do not cover the product, this can result in overheating or fire.
- Place the product standing upright on a level, stable surface.
- When using the product it must always stand upright – it must never be used on its side.
- Pull out the plug from the power point when the product is not in use. Do not pull the power cord to pull out the plug.
- Leave a free space of a least 30 cm around the product to ensure safe and correct functionality.
- Check that the product can oscillate without colliding with or being obstructed by anything in the near vicinity.
- Never poke any objects into the grille in product. It is especially important to explain this to children to make sure they understand the risks.
- Do not use the product if the power cord or plug are damaged, if the product has tipped over, or if it is not working properly.
- A damaged cord or plug must be replaced by an authorized service center or qualified person to ensure safe use.
- Do not use the product outdoors.
- Do not use the product near a bath, shower or swimming pool. Do not expose the product to direct sunlight.
- Do not use the product together with an external speed controller.
- Do not use the product near flammable liquids or gas.
- Switch off the product and
- Never leave the product unattended when switched on.
- Repairs must only be carried out by an authorized service center.
- If the product stops working properly, switch it off with the switch on the control panel and contact the retailer. pull out the plug before cleaning.
SYMBOLS
TECHNICAL DATA
- Rated voltage 230 V ~ 50 Hz
- Input power 50 W
- Operating value 0.50 (m³/min)/W
- Power consumption in standby mode (Psb)0.46 W
- Safety class II
- Protection rating IP20
- Sound power level, LwA 59.57 dB
- Max flow speed 22.50 m³/min
- Max air speed 2.40 m/s
- Operating value standard
- IEC 60879:1986 (corr. 1992)
DESCRIPTION
- Display
- Air outlet
- Base
- Power cord
- Air inlet
- Control panel
- Casing
- Air filter
USE
Press the buttons on the control panel or remote control as
follows:
MAINTENANCE
NOTE
Pull out the plug from the power point before installation and/or cleaning.
The product should be cleaned once a month.
- Clean the fan with a soft cloth moistened with mild detergent. Make sure that no water or other liquid gets into the fan.
- Carefully remove the casing and take out the air filter.
- Rinse the air filter with running water.
- Make sure the filter is completely dry before putting it back.
- Replace the air filter and the casing.
- Do not use petrol, solvents, or detergents that can damage the plastic parts.
013881
Description| Symbol| Value| Unit
Maximum fan flow rate| F| 22,50| m³/min
Fan power input| P| 44,80| W
Service value| SV| 0,50| (m³/min) W
Standby power consumption| PSB| 0,46| W
Sound power level| LWA| 59.57| dB(A)
Maximum flow speed| C| 2,40| m/s
Annual power consumption| kWh/a| 14,85| kWh/a
Operating value standard: IEC 60879:1986 (corr. 1992)
Contact: www.jula.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>