anslut 016273 Christmas tree with LED lighting Owner’s Manual

October 27, 2023
anslut

Item no. 016273
CHRISTMAS TREE
WITH LIGHTS
anslut 016273 Christmas tree with LED
lighting

OPERATING INSTRUCTIONS

Important! Read the user instructions carefully before use. Save them for future reference. (Translation of the original instructions)
Care for the environment!
**** Must not be discarded with household waste! This product contains electrical or electronic components that should be recycled. Leave the product for recycling at the  designated station e.g. the local authority’s recycling station. Jula reserves the right to make changes. In the event of problems, please contact our customer service.
www.jula.com 
For latest version of operating instructions, see www.jula.com
2021-05-14
© Jula ABanslut 016273 Christmas tree with LED lighting -
Figanslut 016273 Christmas tree with LED
lighting - Fig 1

SAFETY INSTRUCTIONS

  • Do not connect the product to the mains while still in the pack.
  • Check that no light sources are damaged.
  • Do not connect two or more products together to a power source.
  • No parts of the product can be replaced, or repaired. The whole product must be discarded if any part is damaged.
  • Do not use sharp or pointed objects during assembly.
  • Do not subject the power cord or wires to mechanical stress.
  • This is not a toy. Be careful if using the product near children.
  • Disconnect the transformer from the power point when the product is not in use.
  • The product is not intended to be used as general lighting.
  • Recycle products that have reached the end of their useful life according to local regulations.

WARNING!
The product must only be used when all the seals are correctly fitted.

SYMBOLS

**** Approved in accordance with the relevant directives.
**** Recycle discarded product in accordance with local regulations.

TECHNICAL DATA

Rated voltage 230 V ~ 50 Hz/31 V
Output 6 W
No. of LEDs 300
Protection rating IP44

INSTALLATION

  1. Remove the parts from the packaging.
  2. Angle out the foot of the Christmas tree so that it is at 90° between the four feet.
  3. Put the bottom part of the tree in the foot.
  4. Put the middle part in the bottom part.
  5. Put the top part in the middle part.
  6. Connect the contact parts together.
  7. Fold out the branches.
  8. Place the tree in the required place and plug the plug into a power point.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals