Good Earth RE1342-WHG-02LF3-F LED Disk Light with Power Bank Instruction Manual
- June 10, 2024
- Good Earth
Table of Contents
RE1342-WHG-02LF3-F LED Disk Light with Power Bank
Instruction Manual
RE1342-WHG-02LF3-F LED Disk Light with Power Bank
WARNING AND CAUTIONS
CAUTION
- DO NOT puncture, damage, or dismantle the Power Bank or attempt to replace the battery.
- Keep the LED light away from fire, erosive materials, corrosive and/or explosive gas, and chemical, medical and electronic devices, including magnetized data devices; hot steaming areas, as damage can occur.
- Avoid dropping the LED light as damage to the PC cover or other electronic components can occur.
- The battery works on between 32°F (0°C) to 113°F (45°C), working outside the temperature may cause malfunction.
- Always follow the good practice of charging LED light which contains Lithium Ion battery to its full capacity before operation or prolonged storage.
- Do not hang over beds or on wallpaper.
WARNING
This product contains Lithium batteries. Batteries may leak harmful liquids or
ignitable materials or explode causing injury and product damage.
CHARGING
Before 1st use, plug in USB wall charger (not included) & Micro USB cord
(included) to charge Power Bank.
**BATTERY DURATION*
CONTINUOUS ON
~6.5 Hours
RECHARGE TIME**
TEMPS DE RECHARGE
~7 HoursLight can be plugged
in for continuous use.
EASY INSTALLATION COMMAND® STRIPS BY 3M
Puck Lights Clean surface with rubbing alcohol. Remove red liner. Press
strip onto back of the puck light. Remove black liner. Press puck light to
surface with tab towards you. Press firmly for 30 seconds.
Power Bank Clips Attach clips to back of power bank. Clean the wall
surface with rubbing alcohol. Remove red liner. Press strip onto back of the
clips.Remove remaining liners and
press onto power bank with tab towards you. Press firmly for 30 seconds.
Function Controller Clean surface with rubbing alcohol. Remove red liner.
Press strip onto back of the function controller Remove black liner. Press
function controller to surface with tab towards you. Press firmly for 30
seconds.
INDOOR USE ONLY
For more product and warranty information, go to:
www.goodearthlighting.com
STRIP REMOVAL
Never pull the strip away from the surface! Always pull along the
surface.Stretch each strip slowly
against the surface at least 12” to release. Stretch each strip slowly against
the surface at least 6” to release.
Command is trademark of 3M
IMPORTANT: Failure to follow instructions carefully may cause damage.
CAUTION: Do not hang over beds or on wall paper. Mount again with
Command® Small and Medium Refill Strips. Need to throw away old fixtures? Locate
a local recycling center at call2recycle.org.
2 WAYS TO MOUN
Star Connection Daisy chain Puck lights
These lights can be attached in 2 different ways using the “Out” ports on
the square Function Controller.
Note: Maximum of 3 Pucks can be linked together.
OPERATION
Function Controller
On: The light(s) stay on continuously.
Auto-Off Timer:
15m: 15-min auto shut-off.
30m: 30-min auto shut-off Power Button
Press once: Turns puck lights ON/OFF
Press and hold: Slowly Dims/Brightens puck lights
Power Bank **Use the power bank as a power source. Remove power bank to
charge.
Note: use any 5V1A USB adapter (not included) for continuous use.
6-YEAR LIMITED WARRANTY
Good Earth Lighting®
– The manufacturer warrants this lighting fixture to be free from defects in
materials and workmanship for a period of (6) years from the date of original
purchase by the consumer. The fixture is not warrantied for use in a commercial
or retail application. The warranty is limited to use in a residential
environment. We will repair or replace (at our option) the unit in the
original color and style if available, or in a similar color and style if the
original item has been discontinued, without charge. Defective units must be
properly packed and returned to the manufacturer with a letter of explanation
and your original purchase receipt showing date of purchase. Call
1-800-291-8838 to obtain a return
authorization number and an address where to ship your defective product.
Note: C.O.D. shipments will NOT be accepted. The liability of the manufacturer
is in any case limited to replacement of the defective light fixture product.
The manufacturer will not be liable for any other loss, damage, labor costs,
or injury which is caused by the product. This limitation upon the liability
of the manufacturer includes any loss, damage, labor costs, or injury which is
(I) to person or property or otherwise; (II) incidental or consequential in
nature; (III) based upon theories of warranty, contract, negligence, strict
liability, tort, or otherwise; or (IV) directly, or indirectly related to the
sale, use, or repair of the product. This warranty gives you specific rights,
and you may also have other rights which vary from state to state.
FCC STATEMENT: This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Caution: Changes or modifications of this product is not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE:** This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC responsible party name: Good Earth Lighting Inc. Address: 1400 E Business Center Drive, STE 108 Mount Prospect, IL 60056 USA. Telephone number: 1-800-291-8838
© 2022 Good Earth Lighting, Inc.
1400 East Business Center Drive, Ste. 108
Mount Prospect, IL 60056 REV08.22
References
- Call2Recycle | Leading the Charge For Battery Recycling
- Decorative Light Fixtures, Energy-Efficient Lighting | Good Earth Lighting
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>